Will Trailer Wiring Harness 20028 Fit a 1998 Ford F-150 without Factory Trailer Connector
I have a 1998 Ford F150. The flat connector does not work. I spliced in a standard receptacle, tail lights, stop and turn signals. The problem is that the clips at the wires are always dirty, and I have to clean them almost every time I use...
Replacement Extang BlackMax Tonneau Cover on my 1999 Ford F-150 with a 6.5 Bed
I purchased a 1999 ford F150 with a 6.5 foot bed. I am fairly certain that it has a Extang Tonneau soft cover on it, no model number but the frame looks like photos I have seen on your site and the clamps are the same as your part number EX22000106....
Will My Factory 4-Pin Work After I Install Tow Ready 7-Way Harness for a 1997 Ford F-150
Installation looks easy enough. After I install the 7 wire cable and mount the 7 pin connector, leaving my factory 4 pin in place, will my 4 pin still function? | The factor 4-Pin should continue to function. The 7-Way Wiring Kit just connects...
How Many Corner Slide-Out Caps Come with JR Products Corner Slide-out Cap p/n 372540
how many come in a package of corner slideout caps #372540 | The JR Products Corner Slide-out Cap # 372540 is sold as a single cap and will replace 1 worn or damaged extrusion cover. |
Recommended Weight Distribution System When Loaded Trailer is 50% of Tow Vehicle Weight
If you find that you are able to tow the trailer, but it weighs more than 50 percent of the weight of your 1997 F-150, you will want to look at a weight distribution system. From your websit. My trailer will be a hauling trailer - flat bed. Above...
Brake Controller And Wiring Adapter Recommendation For 1998 Ford F-150 With Factory 4-Way
My 98 f150 has a plug in for a brake controller but it only has a 4 pole connector at the rear. I want to tow a one axle trailer with electric brakes. Can I simply install part #118242 and a brake controller and be able to use the trailer...
Trailer Hitch Receiver and Wiring Harness For a 2000 Honda S2000
Hi, Im interested in the S2000 hitch C11198 but it says that it only fits 2004 - 2009 S2000s. Do you guys have one that will fit a MY 2000 S2000? Thanks | The Curt Weld-On 2" Receiver # E17 will allow you to have a receiver custom fabricated...
Replacement Oil Seal for AL-KO 568303
The number on my seals is al-ko 568303 what seals would I need? | To replace your AL-KO 568303 seal you will want the Oil Seal # 91030. This seal has the same inner diameter of 2.750 inches and outer diameter of 3.779 inches. It is a confirmed...
Recommended Transmission Cooler For a 1999 Ford F-150 With 4.6L V8
I have a 1999 F150 XLT with a 4.6L V8 and 4-SPD auto O/D transmission. What type of transmission cooler is recommended and additional parts? Also is there a video to show how this is done? | I recommend using the Derale Series 8000 Plate-Fin...
Derale Oil Cooler that Fits 1999 Ford F-150 5.4 Liter
Will this fit a 1999 ford f150 5.4l? | I did some checking and your 1999 ford f150 5.4l has oil filter threads that are M22x1.5 which means that for a cooler kit you'd want the # D15405 which includes a fitting that matches this size. The cooler...
Measurements of Draw-Tite Trailer Hitch Receiver # 41920 for 1998 Ford Light Duty Pickup
Trailer hitch # 41920 measurements | The Draw-Tite # 41920 is confirmed to fit your 1998 Ford Light Duty truck. I'm not sure which measurements you need exactly so I went out to the warehouse and measured the distances between each set of bolt...
What Parts Are Included in Bully Bumper Mount Backup Light PL-807
the price you have listed here for the pl-807 bully bumper lights is the price for 1 or set? think you | Bully Bumper Mount Backup Light # PL-807 is sold as a single light unit so if you want two of them order a quantity of 2. Each light includes...
Solution for Reese Signature Series Hitch that Needs New Legs
Would these fit a signature series? | The Signature Series fifth wheel hitches have been discontinued for long enough that replacement parts are no longer around. The Signature Series line was replaced by the Elite Series so if your Signature...
What Fifth Wheel Bracket Install Kit Will Fit a 1998 Ford F-150
i am going to install a 15k reese fifth wheel hitch in my ford f150 and i need the brackes and bolts that fit the frame under the bed can you tell me the right ones i need thanks ? | The install kit for a 1998 Ford F-150 is Reese part # RP50042-58....
What Size Staples are Recommended for Installing Bunk Board Carpet on Boat Trailer
Hello, staple gauge and length for new carpet installation- using air gun. THANKS | We typically try to use 1/2 inch stainless steel staples when we install the CE Smith Deluxe Marine-Grade Carpeting, # CE11330, but 3/8 inch staples will work...
Truck Bed Bike Rack Recommendations for a 1999 Ford F-150 with Bed Liner
I have a bed liner installed in the back of my 1999 Lariat flair-side bed. Do you make a Swagman bike carrier which can be 1 adjusted to allow for the bed liner ? 2 Have a Swagman bike carrier for three bikes ? | You can use a truck bed bike...
Will a Hitch for a 2022 Ford Expedition Fit a 1997 Ford F-250
Will the reese hitch on 2002 ford expedition fit a 1997 ford f-250 | A hitch like the 41527 you referenced is designed to fit the 1997-2002 Ford Expedition. The hitch you have for your 2002 Ford Expedition will not fit a 1997 Ford F-250. There...
Does Roof Vent Cover part # MA00-933067 Fit On Wedge Shaped Ventadome Roof Vents
Vent Cover for correct on wedge shape fan vent? | Since you said the roof vent has a wedge shape that means you have a Ventadome style roof vent like the part # V2119-601-00 which the Roof Vent Cover part # MA00-933067 is designed to fit without...
Trailer Hitch and Wiring Recommendation for a 1999 Ford F150 Short Bed
Putting on tow hitch on 99 F150. Two wheel dr Standard 6 foot box Need to know which wire harness and tow hitch to order part numbers | The most popular hitch we sell that has been confirmed to fit your 1999 Ford F-150 with a standard 6 foot...
Replacement Air Bag Helper Spring System for a 1997 Ford F-250 Light Duty Pickup
Hi, I have a 1997 ford light f250 that needs replacement bags. Any suggestions? Thank you | Depending on the age of your Air Bags on your 1997 Ford F-250 Light Duty truck they may be obsolete. If you can find any identifying marks on the outside...
Complete Flat Towing Setup For A 1997 Ford F-150 4X4
Do you have a Blue Ox baseplate for a 1997 Ford F-150 4X4 with tow hooks in front. | For your 1997 Ford F-150 4x4, you can use the Blue Ox Base Plate Kit # BX2146. This base plate kit will only work if you have tow hooks in the front for the...
Instructions for Removing Factory 7-Way on 1999 Ford F-150
how to remove the seven prong trailer plug on a 99 ford f150 | When it comes to removing the 7-way on your 1999 Ford F-150, there should be a grey locking clip like what is in the picture that I have attached. You'll just need to use a screwdriver...
Does Pilot Nerf Bar Hardware kit part # NB-351BRK Include Brackets for Both Sides of Vehicle
Is this parts for both bars or just one side? | The Pilot Nerf Bar Hardware kit part # NB-351BRK that you referenced comes with hardware for both sides of the vehicle. |
Will Curt Bumper Hitch Part E-3S Fit a 1999 Ford F-150
Will this hitch part#E-3S fit a 1999 ford f-150 stepside. 4.2 V6. | If your 1999 Ford F-150 is equipped with a step bumper, then yes this hitch can be used. You may need to drill new holes factory holes do not line up. You can also use a standard...
Filter Your Search
Contact and Help