Will a 4.80-8 Trailer Tire Fit in Place of a 4.00-8 Tire
I have seed planter with implement tires of 4.00 x 8. Will a 4.80 tire fit? | Yes, a 4.80-8 tire will fit in place of a 4.00-8 tire. That is why a lot of times you will see both sizes in the product's title or description and even on the actual...
How Many Times Can the Cylinders Be Reused on the Eva-Dry Renewable Dehumidifier?
Hello! How many times can the Dry Units be regenerated? Thank you | Hey Larry. The cylinders included with the Eva-Dry Renewable Dehumidifier Air Dry Kit w/ 2 Cylinders item # ED74FR can be reused for up to 10 years. If you have any additional...
Compatibility of 2017 Nissan Kicks Mexican Model with Curt Trailer Hitch
I know this will fit a 2019 Nissan Kicks. I have a 2017 Nissan Kicks at my home in Mexico and would like to know if it would fit it. I realize the Kicks was not available on the US until 2019 model year but was available to the rest of the world...
Weight of the 2025 Nissan Kicks Curt Trailer Hitch
I have a 2025 Nissan kicks. Can you tell me the weight of the trailer hitch? | Hey Max, thanks for reaching out! The Curt Trailer Hitch Receiver # C53RJ weighs in at 21.75 lbs. Are you asking for shipping purposes, or just trying to figure...
Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Is There Longer Cable Setup Available for Benton ShellRaiser
Is there a longer cable I can purchase for the Benton Shellraiser? It took me a while to wrapped the cable on the roof rack of my 20 Nissan Kicks. A longer cable would significantly make installation easier and faster. | Hey Diana, I wish there...
Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
Troubleshooting Trailer Wiring When Connecting a 4 Flat Vehicle Side to 4 Flat-5 Wire Trailer
I have a 2001 Isuzu Rodeo and was recently trying to connect the connector wires to my trailer. My Rodeo is setup to use a 4 flat female end that runs to 4 wires Ground, Tail, L Turn, R Turn to a converter that connects the 4 wires of the end...
Air Lift 1000 Universal Air Spring Kit for 2025 Nissan Kicks
Hi Etrailer team I’m interestig in the Air lift 1000 to install in SUV Nissan Kicks 2025. The internal spring diameter is 3.5” and the high or gap between spring seat is 6.75”. Could you recommend me a kit for my SUV? | Hey Elias! Thanks for...
Trailer Hitch and Wiring for 2009 Mercedes R320 Diesel
I have a 2009 mb R320 diesel w251 . The information on the web site indicates the class 2 trailer hitch and separate wiring packages are for a r350 MB the wiring package is with brake controller and 7 way. Can to clarify the correct products...
Looking For Mirror To Help With Visibly On 2019 Nissan Kicks
When I make left hand turn I frequently run over curb due to my lack of perception. Which mirror would be best for me? 2019 Nissan kicks Thanks | Hello Carrie. Gotta watch out for those curbs, they'll get ya'! We do have some mirror options...
Can a 3-Wire to 2-Wire Trailer Wiring Harness Converter be Bypassed
can i by-pass a 3 to 2 wire taillight converter in any way | The only way to bypass a 3-wire to 2-wire trailer wiring harness converter (assuming your vehicle has a 3-wire or separate tail light system) would be to convert your trailer to a...
Diagram of the Portion of the Fascia that Needs Trimmed to Install Curt Hitch # C13103
do you have a sketch of how much to trim do you cut around hitch support bar ? | I attached a copy of the installation instructions for the Curt hitch # C13103 which is confirmed your 2007 Mercedes R350. The installation instructions have...
Recommended Hitch for a 2022 Nissan Kicks
Does the DT94GR fit the 2022 Nissan Kicks? | I checked with Draw-Tite and I can confirm that the Draw-Tite item # DT94GR does fit the 2022 Nissan Kicks. This hitch is custom fit and bolts directly to your Nissan with included hardware, I have...
Should Radial or Bias Tires be Used for a 3500lb GVWR Pop Up Camper Trailer
Vehicle - 2011 Coleman Sun Valley pop up camper. Fully loaded - 3500lbs I cant seem to figure out which tire to get. It seems there is much debate on trailer tires, whether to get radials or bias ply. My stock tires are Kenda ST185/80D13-D and...
Where is Connector Found on 2001 Isuzu Rodeo for Installing Hopkins Trailer Wiring Kit HM43215
I cannot see the plug you guys talk about in the jack compartment, however there is a similar plug on the bottom beside the spare tire is that the correct plug, and do I have to do any other connections? | The plug you have found is the correct...
Trailer Hitch For A 2019 Nissan Kicks
How much does the DrawTite 2” receiver weigh vs. the Curt 1.25” receiver for the 2019 Nissan Kicks? | The Draw-Tite Max-Frame Trailer Hitch Receiver # DT94GR weights 39 pounds. The Curt Trailer Hitch Receiver # C11563 weights 27 pounds. I...
Trailer Hitch Receiver For Carrying a Bike Rack With a 2022 Nissan Kicks SR
Hello looking to purchase a 2022 Nissan Kicks SR Need a hitch 2 X2 or Class 3 hitch for bike rack. Do you have any recommendation? | The Curt Trailer Hitch Receiver # C11563 is our only custom fit receiver I can find for your 2022 Nissan...
Is The Older Thule 1050-09 Bike Rack Compatible With Factory Crossbars?
1050-09 thule Is this compatible with my nissan kicks sr 2020 I have a cross bar already? Thank you | The older Thule 1050-09 bike rack is specifically for square bars and there are not any adapters to allow fitment onto your factory crossbars....
Is Cutiing Required for Installation of the Mercedes-Benz R350 Trailer Hitch # C13103
I would like to know if there is any cutting of the oem bumper required in order to fit your trailer hitches? | You will not need to cut the OEM bumper for installation of the Curt Trailer Hitch, item # C13103, for the 2008 R350 by Mercedes-Benz....
Is Play Between Hub and Axle on Trailer Normal
I have had this trailers for 3 months. I feel like the trailer is louder going over bumps compared to when I first got it. It seems to be coming from where hubs connect to the axle. Although I feel the lug nuts are tight, When I pull the...
4-Way Trailer Wiring Recommendation for 2002 Isuzu Rodeo
HI first Id like to thank you for you time to answer my question. Ok I have a 2002 Isuzu Rodeo and I want to install a 4way trailer conception. But I only see a connecter with 2 wires one hot and on ground I believe they are the running lights...
Trailer Hitch for a 2012 Mercedes R350 BlueTec
Will this hitch also fit the Mercedes 2012 R350 Blue Tech diesel model? Also, where is the best place to get the hitch installed once I buy it? I doubt that a dealer would do the work but I am afraid to trust non-Mercedes technicians, especially...
Removal of Fascia on Mercedes 2008 R350 When Installing a Curt Trailer Hitch, Part # C13103
Once I get the facia off, I can install the hitch. Any tips? Ive removed the 4 bolts under the rear bumper. How do I get the rest of the facia off? CURT 13103 model hitch. | I spoke with my contact at Curt and he informed me that the underbody...
Filter Your Search
Contact and Help