Result: knobs

Id like to replace my fan switch, but when I bought my 94 Roadtrek RV, the fan was missing knobs. Do you sell knobs to fit the FVK1031-05 fan switch? | Id like to replace my fan switch, but when I bought...

This kit comes with two knobs and two hooks like you mentioned wanting. | I need a set of replacement hard ware for the 2500 . The hooks and knobs. 2 sets if possible. Thanks | The replacement hardware kit you need for the Longview...

Blue Ox BRK2012 - Do you carry the following parts: - Black plastic push pad - Knobs for the gain controls Thanks. | Blue Ox BRK2012 - Do you carry the following parts: - Black plastic push pad - Knobs for the gain controls Thanks....

Yes the Replacement Manual Lift Knob # FVK1142-09 does fit the Fan-Tastic roof vent LF5000RBT that you have. | Can you tell me if your part #FVK1142-09 works as a replacement for my FANTASTIC fan model LF5000RBT? Looks like...

According to Titan, the # T2343400183 knob-latch type coupler should be tightened until it can no longer be turned by hand, then backed off to the previous notch. | I would like to know the recommended tightness for the Titan...

Compared to the LaSalle Bristol Utopia RV Kitchen Faucet - Dual Knob Handle # 34420380R143ABX that features similar specs, but has a 8" on center mount. | Hi, I am looking to replace the faucet from a 2001 Roadtrek, model dodge...

The Universal Mounting Panel for Redarc Tow-Pro Trailer Brake Controller Control Knob item # 331-TPSI-001 which measures 1-1/4 by 1 inch. | hello im trying to install trailer hitch and trailer brake controller on a 2010 ford...

I've included a picture below showing what the knob looks like once installed. What kind of trailer are you planning to tow? | Good morning I am trying to upfit my 2003 E350 super duty with a trailer braking system. I want...

The panel which houses the light and control knob I would say is around 1/4" - 1/2" thick so that is all that would sit inside the trailer. | Does the bottom of this fan extend into the living quarters? If so, how much? | The...

These are the replacement hooks and knobs for Custom Towing Mirror # CTM2500, which you referenced. | Regarding: Product Code CTM2500. I purchased these mirror extensions for my van and love them but have lost the plastic clip...

To install the Redarc Tow Pro Elite part # RED44FR in your 2004 Ford E-250 all you need is the install harness part # RED87FR which plugs into a port under the dash. Basically the knob gets mounted on the dash in an accessible location and then the module would get mounted out of the way. |

Next you'll turn the blue knob until "Pilot" is facing forward towards you and press down the button to light the pilot. | I just purchased a 2005 monoco class c motor home and I am trying to fig your how the water heater works...

The hooks are secured using knobs that keep the hooks in place. Shaking and bouncing will cause these knobs to loosen, possibly resulting in the loss of the bikes. | I just bought a 20 ft. rv with back entrance...

This is a proportional brake controller that only puts a small knob on the dash of your van. What are you planning on towing? | 2001 Ford E-150 Econoline Club Wagon Chateau Standard Passenger Van 2-Doo I only have a 4 pin...

The Redarc Tow Pro part # RED44FR is a proportional controller that will only require mounting a small knob on the dash like what I attached a picture of. | I bought a 2013 E-350 super duty motorhome with the factory brake...

Pro Tip: Spay some lubricant like WD-40 or PB Blaster on the rubber isolators to make it easier to remove the hanger knobs. | I purchased the replacement CURT trailer hitch hardware from eTrailer for this hitch and installed...

There is a control box that gets installed under the dash, out of sight and then a control knob that gets mounted on your dash wherever you prefer. | I have a 2014 Ford E350 Thor Chateau RV, looking to tow a 16’ car trailer....

If you're wanting a more traditional Redarc brake controller that is a knob that install in the dash, I recommend using the Redarc Tow-Pro Elie Brake Controller part # RED76CR. | I have a 2010 van E-150 I need part number for...

If there is a leveler knob on the brake controller it could be a problem. | This is a Voyager unit purchase for a E350 van in 1999. The van has a towing package. Brakes are not working with pedal most of the time, and when...

I also really like the Redarc controllers for the reason you mentioned as it only puts a very small knob on the dash of the vehicle and because the controller uses an inertia sensor to decide how hard to apply the trailer brakes....

For the roof crossbars you can use Inno Square Crossbars # INB165 along with Inno Feet for Rain Gutters # INSD, which clamp onto your van's rain gutters and tighten down with locking knobs built into the covers. You can then mount a bike rack such as Malone Pilot TC ST Roof Bike Rack - Wheel Mount - Clamp On # MPG2103, which allows one bike to be mounted onto the crossbars by using the included clamps. |

The only part visible is the control knob. This means no bulky controller to bang your knee on while driving. | I need an electric brake system for a 2013 ford E350 xlt van. No factory setting that I knownof | Hey Glenn. To...

The main unit for this brake controller installs behind the dash, with only the control knob showing in the cab of your motorhome. You would then need the Redarc Plug-and-Play Wiring Harness for Tow-Pro Trailer Brake Controllers # 331-TPH-005 for installation using the factory port. |

I like this controller over the others we offer because the main unit installs out of site with only the control knob showing on your dash, which will give your Ford Van a clean factory look. | Hello. I read a number of your...