Recommended Tire Chains for a 2023 Rivian RS1 275/50 R22
Hello, I’m looking for low profile 16mm or smaller snow chains/cables for my 2023 Rivian RS1 275/50 R22. Would these work? Thanks! | Hey Julie, thanks for the information and the picture! I checked with Rivian and we've only got one set of tire...
Hitch for 1952 Chevy 3100 Pickup Truck
MY 52 CHEVY PICKUP 3100 IS 46inch WIDE FRAME. DO YOU HAVE A HITCH TO FIT THAT? | The only hitch that would work for you is a weld-on such as the Curt # 15903. This is a universal hitch that is a Class V with a 2" receiver and works with frames...
Which Kat's Block Heater Fits 2025 Mitsubishi Outlander SE 2.5 Liter
Will this heater work, without modification, on my 2025 Mitsubishi Outlander SE? Please confirm the location for this vehicle as well. | Hey James, yes the Kat's Heater part # KH11812 that you referenced is a confirmed fit for your 2025 Mitsubishi...
Would Thule Hullavator Work With Rivian R1S OEM Roof Rack?
Im trying to install the Thule Hullavator on a Rivian R1S. I already have the Rivian Cargo Crossbars so Id prefer to use these if possible. The Hullavator requires the crossbars to overhang and the Rivian Crossbars dont. Is there a way to stackinch...
Where Do You Measure From On The Trailers Coupler to Install The Pole-Tongue Adapter # EQ95-01-5950?
For the tongue pole adaptor, you mention in the video that it need to be install between 27 to 32 inches from the reveiver in the tongue. Do we mesure from the tip of the receiver or the middle, because if I mesure from the tip of the receiver...
Why Choose a Powered Taillight Converter Over a Non-Powered Model
What dictates the need between using a powered Tail light convertor Vs a non powered? | There's a couple of factors that determine that. On older vehicles, very few vehicles needed a powered converter, because the vehicle's electrical system...
Will etrailer Spare Carrier # e98ZR Work with Rivian R1S 20
Does this fit a rivian r1s 20 inch all terrain tire? 275 / 65 / R20 | Hey John, yes the etrailer spare tire mount part # e98ZR that you referenced will work with the wheel and tire Rivian R1S 20 inch all terrain tire that you referenced. |
Recommended Gooseneck Hitch for a 1953 Chevy 6400 Dually
Hello, I have a 1953 Chevy 6400 dually i.e., the 2 ton version - GVWR plate has 16,000 lbs.. Between the left and right frame at the rear axle I have 35.5 between the frame rails and it is flat - very, very similar to the 2024 Chevy 4500. I...
How to Tell if Power Mountain Tallboy Off-Road Bottle Jack Will Work with a 2023 Rivian R1S
what jack can you recommend for changing tires on my Rivian R1S 2023 and Intech Sol Dusk Rover off road package travel trailer? Will the Tallboy pm34fr work with a Rivian puck? | Hey Darin, thanks for reaching out! The Power Mountain Tallboy...
Will Dextar Conventional Steel Wheels Fit on a Vintage Truck
I know that these rims are for trailers, but will they work on a 1954 3100 Advance Design Pickup with a 6 on 5.5 bolt pattern? | The Dexstar 15" Conventional Steel Wheel, # AM20514, are basically the same wheels that were used on vintage 1940's...
Does The GE Appliances RV Refrigerator GE58FR Come With A Mounting Bracket?
Does this with mounting brackets? | Hello Raymond, thanks for reaching out. The mounting brackets are not included with the GE Appliances RV Refrigerator # GE58FR. It requires a GE approved top bracket part BMT-GPV10. This is not something we...
1947-1953 Chevrolet Advance Design Pickup 3600 8 Lug Wheel
It is well known on many forums that you all have a Dexstar Black steel rims that is a perfect fit for 8 lug vintage pick ups. Any chance I could get a part number? | I believe the wheel that they are refering to is the Dexstar Conventional...
Replacement Jack For 2001 Stratos Bass Boat Trailer
I have a 2001 Stratos Bass boat with a Fulton center bolt swivel jack onto a welded plate on the trailer. I would like to upgrade to the Fulton F2. My holes on the plate are 3X3 on center. Will the F2 work? Can I send you picture? Thank You...
Solution for Trailer Hitch Receiver on 1952 Chevrolet 3100
Do you sell a bolt on Class III hitch for a 1952 Chevy 3100 truck advance design? | I do have a solution, but there are no custom-fit bolt-on hitches for your 1952 Chevy 3100. What you can use is a universal hitch like the # 41990-07. This...
What is the Battery Life for Hopkins Wireless Magnetic Tow Lights
What is range of battery life for these lights? The check battery level indicator light every 2 hours statement has me concerned. I drive for much longer stretches than that and dont wish to carry excessive spare AAs or replace them every couple...
Installation Instructions for Wiring a 2008 Volkswagen Rabbit to Tow a Trailer
My question is about the electical hook-up. Can I splice a 4-flat connector directly into the wiring harness, or do I need some kind of powered module dure to the fact that it6 haqs LED lights? | Due to the MX (Multi-Plexed) wiring system on...
Why is a Stabilizing Strap Recommended on Curt Hitches and what is Meant by Non-Trailer Load
What is meant by stabilizing straps for non-trailer loads? | Non-trailer loads are hitch accessories like bike racks and cargo carriers. Basically anything that is not a trailer that you could put on a hitch. Curt recommends you use a Curt Trailer...
Overall Length of Bristol Double RV Waste Valves # 34466ND14AAR
Hello Could you please provide me with the outside to outside over all length, hub to hub. Thank You | The Bristol Double RV Waste Valves # 34466ND14AAR is about 9" long outside to outside. Attached is a photo showing this as well as a review...
Is Trimming of the Foam Absorber Required for the Curt Hitch On a 2010 Mini Cooper Convertible
have a question about hitch and hard form . I removed the bumper today for preparation for hitch installation. The bumper has the hard foam but it is wedge between the front and back metal bumper with a full metal back hard foam cannot be...
Trailer Hitch and 4-Way Wiring Recommendation for 2018 Mitsubishi Eclipse Cross
I need a hitch and 4 wire harness for a 2018 mitsubishi eclipse cross | For your 2018 Mitsubishi Eclipse Cross we have the Curt hitch # C13273 which is a confirmed fit and then for 4-way wiring you'd want the part # C56296 and you'd be set. |
Replacement Curt Trailer Hitch Hardware Kit for a 2009 Volkswagen Rabbit
Hi - I recently received a CURT C11074 Trailer hitch for the 2009 VW Rabbit from a friend who no longer has their MK5 rabbit. Is it possible to purchase *only* the replacement mounting hardware for this specific mount instead of the generic...
Will the Dexstar Conventional Steel Wheel Part # AM20766 Work with a Tire Tube
Will the Dexstar # AM20766 accept a tube required with the various tube type wide white wall bias ply tires? | I spoke with my contact at Dexstar and they informed me that you should have no trouble using the Dexstar Conventional Steel Wheel...
How to Prevent Exhaust Components from Contacting the Trailer Hitch
I purchased the replacement CURT trailer hitch hardware from eTrailer for this hitch and installed the 11074 on my 2009 4DR Rabbit. However - after install, I now experience a lot more noise at low RPMs. Theres vibration being transmitted back...
Troubleshooting Turn and Brake Lights not Working with Running Lights on, 2009 Volkswagen Rabbit
I have the same problem than the VW GTI guy. After I have wired the kit according to the 2-wire method into my 2009 Rabbit, turn and stop light are working as long as the running light is not on. I have tried also the different 3-wire methods...
Filter Your Search
Contact and Help