Recommended Air Springs Compatible with B&W Gooseneck Hitch on 1999 Ford F-250
1999 f250 superduty w/B W gooseneck in bed | The Air Lift LoadLifter 5000 Air Helper Springs - Rear Axle # AL57291 is a confirmed fit for your 1999 Ford F-250 and is designed for compatibility with B&W gooseneck hitches. I've attached a video...
Replacement Trailer Wiring Harness for a 2003 Ford F-350
I am looking for the OEM wire harness that runs from the frame connector too the 7 way plug. I have purchased a used 2003 Ford F-350 and they have spliced a 7 pin Pollard in the truck, this birds nest of wiring is having poor connections. Can...
How to Install the 7- and 4-Pole Trailer Connector Socket # HM40975 to 4-Way Flat on Vehicle
How do the wires for the 4 way flat attach to the back of the new plug? | The 7- and 4-Pole Trailer Connector Socket # HM40975 that you referenced has a US Car Connector on it. This plugs into a connector that is typically already installed...
Winch Recommendation for Moving Rolling 13,000 lb Load Up and Down Slope
Ill be winching trailers up to 13k pounds or so, uphill, then eventually need to roll them back down under the same control. What are the features/winch types I need to look for in order to make sure I will be able to do this? | In general...
What Is the Correct 5th Wheel Install Kit for a 2001 Ford F-350
What frame bracket kit do I need to fit the above mentioned truck? I see several options but theres nothing explaining the differences. Im just looking to mount a standard non sliding fifth wheel for very occasional use. | There are two types...
Hooking Up 5th Wheel Trailer to Lifted Truck with Gooseneck Hitch
Hi have 2005 Ford 350 1 ton will ball setup in the bucket. The truck has a 4 inch lift. Top of box to ground is 60 inches and bottom of box to ground is 39 1/4. I am looking to buy a 5 wheel and trying to figure out what I need for setup....
Is There An Air Bag Kit for a 2006 Ford F-250 That Works With a Gooseneck Hitch
I have a 2006 f250 powerstroke. Was wanting to put an air lift on it. I currently have a Reese Quikgoose II gooseneck hitch. Does anything fit? | I think you meant the Curt Quick Goose 2 Gooseneck Hitch part # C640-644 which is made by Curt...
Comparing the Reese Install Kits RP50082-58 and 50043-6008 for a 2001 Ford F-350
I got a previous answer stating this: : There are two types of install kits for your 2001 Ford F-350, custom fit kits which do not require any drilling into the frame and universal kits which do require drilling into the frame. That said, each...
Replacement 7-way Trailer Wiring Harness for 2002 Ford Super Duty
I have a 2002 with the square plug not the round where it hooks to the truck and nothing works do you have an idea | The # 118243 connector you referenced isn't a confirmed fit for the 2002 Ford Super Duty. My contact at Tekonsha tells me that...
Will 80" x 60" Cargo Net fit 2012 Ford F-250 Short Bed
Is the 60 inch x 80 inch cargo net what you recommend for a 2012 F250 Crew Cab short box? | Absolutely; the ProGrip Cargo Net for Full-Size Truck Beds # 317-901800 is 80" x 60" which makes it a perfect fit for the 6-3/4' bed that you have on...
Is RBW 5th Wheel Hitch Compatible with Reese Install Kit # RP30156
Will this 5th wheel hitch fit the Reese RP30156 kit ? thanks | Your RBW fifth wheel hitch may be compatible. The Custom Install Kit # RP50081-58 is compatible most RBW hitches, but some will not fit properly. If you write back with the model...
Front Mounted Receiver for Motorcycle Carrier on 2001 Ford F350
Im looking for an under bumper front hitch for my 2001 f350 to connect a motorcycle rack. Which one? | Two designs of front mounted hitch are available for the 2001 Ford F350. One mounts to the front of the frame members, and the receiver tube...
Can the Demco Recon Gooseneck-to-5th Wheel Be Used With a Sidewinder If the Turret Is Locked
I have two trucks one is a Ford F-250 with a 6’ bed and one is a Ford F-350 with a 8’ bed. I have Reese sidewinder on my 5th wheel. If I lock the sidewinder out can I use the DM8550045. My 250 has the factory pucks. My 350 has a gooseneck....
Reese Sidewinder Pin Box for my 2004 Kumfort Fifth Wheel
I have a ford f250 short box .going to pull a 26ft 5th wheel 2004 kumfort 26 ft trailer the #s I found on the pin box is zieman chassis # zn168067 what reese sidewinder would fit my needs thanks in advance | Your 2004 Kumfort fifth wheel uses...
Could Curt Q24 Head be Replaced by Q20 Hitch Head
Can I replace Q24 head with a Q20 head | Yes, the Q20 head part # C16530 could be used to replace a Q24 hitch head. |
Lift Kit for 1,500 lb #9 Torfllex Dexter Axle
I have a Whitewater Retro 509Jr tear camper. I crawled under to look at the axle it looks like it has a Dexter axle with a 1,500# capacity. what lift kit do you recommend? I have attached a picture of the label on the axle. my camper is incredibly...
Replacement 7-Way Connector for 2006 Ford F-350 Super Duty
I have a 2006 f350. Need a 7 pole receptacle replacement that will fit oem configuration..... would like to have pigtail also. My has a short in it that keeps giving trailer fault error while driving. I need the one on the bumper not in the...
Torklift Camper Tie Downs that Fit 1999 Ford F-250 Long Bed with Running Boards and Factory Hitch
Have 1999 ford f250 superduty 8foot bed with running boards and I think factory installed rear hitch. Which model do I need for front and back tie downs | The correct Torklift Tie Downs you'd need for your 1999 Ford F-250 long bed, with running...
Troubleshooting 2002 F-250 Towing Horse Trailer with Working Exterior Lights but No Interior Lights
Hello! I have a 2002 F250 V10 with what appears to be a factory 7 way plug. When I plug my horse trailer in, a 2001 Trails West, the tail lights and running lights work fine, as do the electric brakes, but none of the interior lights or exterior...
Longer Bolt For Timbren Spacers
I want to install spacers but need longer bolts Whats the diameter and full specifications for the 3/8x2 UNF bolts? | To add spacers to your Timbren system you are correct when you said you need longer bolts. The kit you're referencing uses...
Torklift Frame Tie Downs and Turnbuckles for 2012 Ford F-350
I was just typing in an order forTorklift Fast Guns and noted two lengths stated in the video. My camper will sit on a 2012 F350 SRW 4x4 eigh- foot bed. I am assuming I want the longer length fast guns. Am I correct? | The Torklift tie downs...
Does the Spacer Plate for Curt Friction Sway Control have to be Used
Is the spacer plate needed or can I just bolt on the ball plate directly to the frame? | In order to ensure that the Curt friction sway control unit # 17200 is mounted at the proper angle to avoid contact with the trailer when turning the spacer...
How Much Height Does the Bestop EZ Fold Tonneau Cover for a 2008 Ford F-250 Short Bed Add Folded
When the cover is folded open how high above the bed rail does it extend | The Bestop EZ Fold Folding Tonneau Cover part # B1614001 which is a fit for a 2008 Ford F-250 with 6-3/4' bed will sit about 3/4" above the bed while flat. Therefore,...
Replacement Weld-On Mounting Bracket for 2K Pro Series Round, Snap-Ring Swivel Jack
Im looking for just the weld on bracket for this jack. Can I purchase the bracket itself? | The weld-on bracket for the Pro Series Round, Snap-Ring Swivel Jack # PS1401030303 should have holes for the 1/2" pull pin located 3" apart on center,...
Filter Your Search
Contact and Help