!Monaco  x   >   Trailer Valet  x   >  

Will the Rackem RA20 do the job of moving my boat into the garage. I have a two inch ball? Thanks | The Rack'em Trailer Dolly # RA20 uses a 1-7/8" hitch ball but since the trailer will be pulled by hand instead of being towed at a faster pace...

I really want a Trailer Valet but am not certain it will fit my 2011 Jayco 1208 popup camper. The Valets mounting bracket may be wider than the space I have available to mount it on the frame. I also need to know if there will be room to swivel...

My driveway has two inch height of curb. Can trailer valet push 3500lb trailer up ? Looking forward to your reply. | The Trailer Valet XL part # TVXL25 does work on a 10% incline or 5.7 degree angle as confirmed by Trailer Valet. However, the...

Trailer Valet JXS Trailer Jack according to valet trailer support this 2000 cap jack sized with a total trailer of max 2000 lbs. Your web site state to buy a jack with a cap. that 10 to 15 of trailer wt. which would a 10,000 trailer that is...

For trailer jack PS1401440303 1. Can you put a wheel in place of the foot? do you sell this. 2. What is the diameter of the pin used hold the pipe | If you are looking for a jack with a wheel for moving the trailer the Extreme Off-Road...

My OD of my current electric jack’s tube housing a little over 2” dia. is about 3/4” from the propane tank cover. Will the 5K Trailer Valet’s head fit in that space? I’d like to mount it so the input shaft points forward, in the direction of...

Can you switch to a 2 inch ball on the Trailer Valet XL Trailer Dolly with Chain Drive - 2-5/16 Hitch Ball - 10,000 lbs | Yes, you can switch from the 2-5/16" hitch ball to a 2" hitch ball with the Trailer Valet XL Trailer Dolly with Chain Drive...

We will receive our Lance 1475s in February of 2022. Per the paper work, it has a GVWR 3700 and Dry weight of 2832. When storing the trailer I dont believe it will be near the GVWR. Im looking at the TVRVR3 to park it next to my garage, but...

I need a front receiver hitch for 2015 highlander. Will use it to back boat trailer in yard to get it out of the way. any suggestion just used in yard so doesn,t have to be road worthy | I do have an option that will help with maneuvering a...

I am picking up a 2005 Fleetwood Evolution E1 10foot Box today. I have a small yard and tight driveway. I will need to move the camper around the back yard a bit to get it into its storing position. The grade is level with grass. Would you...

I have a 2013 Mastercraft X 30 with the tandem trailer that came with the boat. The boat and trailer combined way 5300 pounds. I am needing to maneuver the boat on the trailer into and out of my garage and it is very tight corners to turn around....

I was just curious how well it does with moisture. If I have a rock driveway that has some puddles after it rains for instance. Thanks. | I spoke with Trailer Valet about the water resistance of the RVR3 Remote-Controlled Trailer Dolly w/ Hitch...

I purchased the TV57FR for my auto trailer and would like to know if you sell the same kit without the foot that attached to the RVR9 so I can install on an different trailer. Also, is the Hitch Base TVBB25 available with a 2 inch ball? Please...

This instructs indicated that the bushings be lubracated. There were no instructions included as to the process of getting it done. So, how? | To grease the bushings on your Trailer Valet XL Trailer Dolly with Chain Drive # TVXL2, you're going...

Hello! I am looking for a trailer dolly and came across the Trailer Valet XL Trailer Dolly with Chain Drive. We have a 2018 suburban and will be towing a 5-6k trailer rockwood roo. My driveway has about a 4degree incline where I am thinking...

How well does this device work over rock chip? Level surface. Trailer Valet XL Trailer Dolly with Chain Drive | The Trailer Valet XL Trailer Dolly with Chain Drive - 2" Hitch Ball - 10,000 lbs GTW # TVXL2 was designed for pavement and level...

So in reference to the trailer Jack wheel . Is there a wheel for trailer swing jack that is rubber ? I have an Overton and the wheel has sooo much trouble spinning around even when I grease it clean it .... so the family fights it and drags...

I want to safely raise and lower a Yakima 66 Rackandroll trailer, loaded with two strapped-down kayaks weighing a total of 100 pounds down a 17-foot long driveway that s 50 inches. Any ideas for how I can do this without unloading the kayaks...

Hi, Can the battery pack be removed from the Trailer Valet RVR3? And can extra batteries be purchased so I can get a longer run time out of this robot doohicky? | The Trailer Valet RVR3 # TVRVR3-BB225 has an internal lithium-ion battery which...

Can I use this to pull instead of just push my trailer? For example if I want to pull it 10 feet forward instead of pushing it 10 feet backward.i | Yes, the Trailer Valet XL dolly # TVXL2 is actually designed to pull the trailer as well as to...

If the foot is removed, can the 2 inch diameter tube fully retract into the 2.25 inch diameter outer tube? Thank you | The tube does not fully retract inside the Trailer Valet JXC Trailer Jack w/ Footplate # TV54FR. |

Does the Trailer Valet xl work with a trailer which has surge brakes? | The Trailer Valet XL part # TVXL25 would work on a trailer with surge brakes. But when you are backing the trailer up you may find that the brakes of the trailer want to...

Your QandA says it will fit 5x3 1/2inch frame but ad says 4 3/4x3 1/2inch frame. My trailer is 5x3. Will that fit? | Sorry for any confusion but the Trailer Valet JXS part # TV34FR that you referenced fits the frame dimensions of 4-3/4" tall...

Where can I purchase it? What is the price? | You do not need to look any further. The drill attachment needed for the Trailer Valet 5X Swivel Jack, part # STC-V211 is part # TVDA. This drill attachment can be used wit either 3/8-inch or...