Will Trailer Valet # STC-V211 Fit an Evolution E1 Pop-up Camper

Updated 06/08/2015 | Published 06/06/2015

Products Featured in This Question

Trailer Valet 5X Swivel Jack and Trailer Mover - Topwind - 15" Lift - 5,000 lbs

(585)

$469.00

Rack'Em Trailer Dolly

(144)

$252.80

Question:

I am picking up a 2005 Fleetwood Evolution E1 10foot Box today. I have a small yard and tight driveway. I will need to move the camper around the back yard a bit to get it into its storing position. The grade is level with grass. Would you be able to recommend the proper dolly. And would you be able to let me know if the travel valet will fit my new to me camper. Thank You

asked by: Pat W

Expert Reply:

The installation bracket for the Trailer Valet # STC-V211 that you referenced takes up to 8 inches of space to mount on the trailer frame. If you have enough room to mount the unit, you should be fine being able to swivel it into position to travel because you should not have anything else extending over the side-rails of your trailer.

In the picture I have attached are the measurements from part # STC-V211. From the bottom of the wheel to the top of the unit while in a parallel position for traveling it is 27-1/2 inches. When in the folded up position, if you leave the handle/arm attached it is 15 inches to the frame of the trailer. If you remove the arm then the distance is 9 inches. From the side of the trailer to the side of the unit and that measures 7-1/2 inches. Finally, the space required for the mounting bracket is 8 inches.

If you find you do not have the room to mount this unit, check out the Trailer Dolly # RA20 which is very simple to use.

expert reply by: Chris O