2010 Ford Radiator Fan

Electric fans do improve fuel mileage and power since they allow the accessory belt drive to turn with less resistance. I did the same conversion on an older Camaro years ago and it cooled better, improved mileage, and power. You'll have to…

Hey Trent, from what I found your 1995 Jeep Grand Cherokee uses an 18 inch diameter clutch fan like the part #D17118. The part number you referenced is 17 inches so it wouldn't work but I would recommend measuring to verify this.

A single yellow light on the Camco RV Power Defender, part #CAM55312 that you referenced indicates an open ground like you can see on the picture I attached. This is typically caused by a broken wire or bad connection in side the socket/plug of your…

Nissan refers to their cab style that is most commonly considered to be "extended cab" as a King cab. The Curt hitch part #13831 that you referenced is a fit for the King Cab 2003 Nissan Frontiers so it would work well for you. I also…

Using Loctite when installing a trailer hitch is not required but it can certainly be used to create an even stronger bond. Blue Loctite like the Blue Stick #LT37643 is plenty sufficient for this application. As long as the hardware for your hitch is…

I did some research on the Highlander Hybrid and did not find anything that says there is a different grounding situation on the Hybrid Highlanders. I did notice that the factory replacement harness, item #118248, uses a chassis ground so grounding…

We have a dual fan setup that is VERY close to what you are looking for but is 1 inch deeper than what you mentioned with the part #D16833. This is rated for 3,750 CFM, is 24 inches wide, 17 inches tall, and 4-1/2 inches deep. If the depth is an…

Hello Jeremy, thanks for reaching out. The Air Lift Air Helper Spring Cradles #AL59DQ will only work with the Air Lift brand bellows-style air bags. They will not work with the Firestone air bags.

Hey John, the Air Lift kit part #AL57230 that fits your 2007 Dodge Ram 1500 is compatible with in-bed hitches but not mega cab models. The part #AL57295 is a fit for the mega cab models and fits with in-bed hitches. The part #AL88295 fits mega cab…

If your 2005 Dodge Ram 1500 came with a factory 4-Way or 7-Way trailer connector at the rear then yes, there is an OEM harness under the driver's side dash and to the right of the emergency brake pedal. Typically this should be blue but the color…

Hello Ernest, We are just here to help with any questions people have, regardless of if they bought the parts through us or not. Unfortunately, we no longer carry the knob for the V2, they have upgraded to the V3 model and we have sold out of all our…

Yes, there is a bolt that goes all the way through that holds the Timbren Rear Suspension Enhancement System item #TGMRG25C in place. I have linked the instructions and an installation video below so you can see the steps involved and all the tools…