How to Wire Up the Rampage SuperBrite LED Tailgate Light Bar # RA960137 to Reverse Light Circuit
Updated 12/08/2014 | Published 12/07/2014
Products Featured in This Question
Question:
I have a 1995 GMC Sierra and I bought the 60 inch lightbar. I have no idea how to wire the white wire for the reverse light. Can someone please explain to me how it is done?
asked by: Adam
Expert Reply:
What you will need to do is find the wiring harness that runs to your 1995 GMC Sierra's taillights and then using a circuit tester like part # PTW2993 test all of those wires till you find one that has voltage when the vehicle is put in reverse.
Once you find the correct wire you will then attach the white wire of the # RA960137 to it using a quick splice connector like part # SWC501746-1 and the light will activate properly when put in reverse.
Product Page this Question was Asked From
Rampage SuperBrite LED Tailgate Light Bar - Stop, Tail, Turn, Reverse - 4-Pole Flat - 49" Long
- Vehicle Lights
- Accent Light
- Tailgate Bar
- Single Light
- LED Light
- Light Assembly
- Strip
- Red/White
- Rampage
more information >
Continue Researching
- Q&A: Are Pacbrake Alpha XD Pro Air Bags Adjusted Equally Or Independently
- Q&A: Can a 4-Way be Added to Trailer Wiring for Light Bar on Boat
- Q&A: Battery Disconnect Solution for 2017 GMC Sierra 2500 Diesel with Two Batteries
- Q&A: Can 4-Flat Plug Be Cut Off Of Blue Ox Plug-In Tow Bar Wiring Kit BLU92HR
- Q&A: How To Add Shelves To E-Tracks Inside a Box Truck
- Q&A: How to Power Blue Ox Patriot Braking System When Vehicles Negative Battery Cable Is Unhooked
- Q&A: Can B&W Continuum Weight Distribution Be Used With Tuson Electronic Sway Control?
- Article: Should You Add an Air Compressor to Your Air Bags?
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Rust Prevention
- Article: Must-Have Flat Towing Components
- Article: Roadmaster Vehicle Specific Base Plates