How to Get Pack'Em Single Trimmer Rack for Open Utility Trailers # PK-6S with Two Locking Uprights
Published 11/06/2014
Question:
Would it be possible to get this unit with two of the locking ends instead of just one? I would pay extra if needed.
asked by: Tony M
0
Expert Reply:
The only way to get the Pack'Em Single Trimmer Rack for Open Utility Trailers # PK-6S installed on your trailer in the configuration where the two locking ends are on your trailer would be to order a quantity of two of these racks and then only use the locking ends of both units.
If you are using this rack for trimmers one locking end would be sufficient as there would be no way to remove the trimmer if it was locked on the one end.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pack'Em Trimmer Rack for Utility Trailers - Qty 1
- Trimmer Racks
- Utility Trailer
- 1 Trimmer
- Drilling Required
- Locks Included
- PackEm
more information >
Continue Researching
- Q&A: Folding Trailer Ramp Add-On Kit For 6 Foot Wide Trailer To Haul Lawn Tractor And Car
- Q&A: 7 Inch Monitor to Replace AOM713WP Monitor on Voyager RV Observation Camera System
- Article: How to Measure a Trailer Axle
- Q&A: Recommended Wheel for ST225/75R15 Goodyear Endurance Tire on a 6,000 lb Travel Trailer
- Q&A: 15 inch Galvanized Trailer Wheel Recommendation with 6 Lug Bolt Pattern
- Q&A: Recommended Gooseneck Hitch Option for Cab and Chassis Ford F-450
- Q&A: Best Way to Drill Holes Through the Curt Gooseneck Flat Plate Part # C65500
- Article: Trailer Wiring Diagrams
- Q&A: Direct Replacement for Carrier Air V RV Air Conditioner
- Article: Trailer Hitch Balls
- Article: Double-Eye Trailer Suspension System Review
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Maintenance Schedule