Recommendations for Leveling the Front of a 1994 Vectra Motorhome
Updated 11/03/2014 | Published 11/01/2014
Products Featured in This Question
Question:
what would recomend
asked by: Terry R
1
Helpful Expert Reply:
If you need 8 inches to allow your 1994 Vectra Motorhome to sit level the part # AM6320 would be the correct product. If you need a different amount of height you would instead want the part # UF48-979051 as it is adjustable.
I attached a review video for the # UF48-979051 for you to check out.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: T Connector Harness That Taps Into Factory 7 Way Harness To Give You 4 Way Flat
- Q&A: Wireless Towing Lights That Can Be Used On A Trailer
- Q&A: How To Determine If Andersen Rapid Jack or Blaylock EZ Jack Will Lift Enough to Remove Wheel
- Q&A: Recommended Equalizer for a 2018 Coachmen Apex Ultralight
- Q&A: Best Suspension Upgrade for 33" Tandem Axles: Road Armor vs Dexter EZ Flex for Ember 22ETS
- Q&A: Can You Mix Bias And Radial Tires On A Tandem Axle Trailer?
- Q&A: Will the Power Mountain Tallboy Off-Road Bottle Jack 27-1/16" Lift be Suitable for My 5th Wheel?
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Trailer Wiring Diagrams
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Change a Trailer Tire
- Article: Trailer Tire Sizing
- Article: How to Measure Your Trailer Wheel Bolt Pattern