Best Place to Mount Automatic Battery Disconnect from RoadMaster Part RM-766
Updated 03/03/2010 | Published 03/02/2010
Question:
Im trying to find a towing battery disconnect switch instead of removing the cable from the battery post. Will the RM 765 work on my Jeep Wrangler 2009, 3.8L with automatic and if so were is the most common spot to mount the solenoid and switch? Also are these very dependable? thanks
asked by: Chris
Expert Reply:
The most common place that they are mounted is on the fender or on the firewall, depending on battery location. The heavy gauge wire leads for the battery are long enough to allow flexibility as far as mounting location. It is not an extremely complex operation, and the simpler the operation, the less problems. We have not heard of any problems with the units we sold so far.
Product Page this Question was Asked From
Roadmaster Battery Disconnect for Towed Vehicle w/ Flat Tow Brake System - Gas Only
- Accessories and Parts
- Flat Tow Wiring Harness
- Battery Disconnect
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Parts Needed to Flat Tow 2025 Chevy Blazer
- Article: Trailer Wiring Diagrams
- Q&A: Parts Needed to Flat Tow 2026 Chevrolet Trax
- Q&A: Recommended Battery Disconnect for 2025 Buick Encore GX
- Q&A: Complete Setup for Flat Towing 2026 Chevrolet Colorado
- Q&A: Why Should You Disconnect The Battery When Flat Towing
- Article: Must-Have Flat Towing Components
- Q&A: Tow Package Recommendation for 2025 Chevy Blazer
- Q&A: Flat Tow Set Up For a 2026 Jeep Wrangler Rubicon
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Can You Flat Tow a 2024 GMC Canyon?
- Article: Flat Towing Package for 2016-2017 Chevrolet Equinox and GMC Terrain
- Article: Can You Flat Tow a 2025 Chevy Silverado 1500?