Could the Curt Vertical Receiver Adapter # C45013 Work on a 2012 Dodge Journey Factory Hitch
Published 10/01/2014 >
Question:
Hello... Will this part fit a 2012 Dodge journey? I have the factory hitch installed where the hitch opening points down, not out. Thanks
asked by: Dennis W
0
Expert Reply:
The Curt Hitch part # C45013 is specifically designed for use with Curt stealth hitches only. Due to pin hole locations, it most likely will not match up with other stealth hitches.
But I did attach picture of this product with all of it's dimensions listed. You might compare this drawing to you hitch to see if it would match up.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Vertical Receiver Adapter - 2" to 2", 4-1/4" Long, 2-7/16" Drop
- Hitch Adapter
- Vertical Adapter
- Ball Mounts
- No Extension
- Fits 2 Inch Hitch
- 2 Inch Rise/Drop
- 5000 lbs
- CURT
more information >
Continue Researching
- Q&A: How Much Space Should There Be Between SumoSprings And My Axle Pad On 2021 Chevrolet Silverado 1500?
- Q&A: Cargo Carrier for Portable Generator That Doesn't Effect Ability To Use Plugs On Generator
- Q&A: Small Water Filter In Tight Space Of Lance 850 Truck Camper
- Q&A: Does etrailer Carry Furrion Chill Cube w/ Heat Pump to Replace Dometic Duo-Therm
- Q&A: How to Raise Hitch Mounted Bike Rack for Additional Ground Clearance
- Q&A: Will The Curt Adjustable Trailer Hitch Receiver # C13701 Fit a 1984 Westfalia Vanagon
- Q&A: How to Use Blu Technology Bleach Free RV Sanitizer Without Filter System or Solo Canister
- Article: Rooftop Cargo Carriers
- Article: Roof Rack Information
- Article: Trailer Wiring Diagrams
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Article: Is It Illegal to Leave My Hitch on My Truck?


