Dimensions of the Base of the Miro-Flex LED Trailer Stop/Turn/Tail Light # STL23R24B
Published 09/26/2014
Products Featured in This Question
Question:
What is the diameter of the light measured behind the widest part of the lens? I have attached a marked copy of your dimensional drawing to show what dimension I am asking about. Thank you!
asked by: Andrew M
Expert Reply:
The picture you submitted didn't make it through unfortunately, but I did attach a dimensional picture of the # STL23R24B that shows the overall dimensions from the widest point of the assembly.
The width of the assembly behind the lens is 4-1/8 inches. The overall diameter is 4-5/16 inches. I believe this is the measurement you are looking for. For a rubber grommet to install this light you would want the part # A45GB. For a pigtail harness you would want the A47PB.
Product Page this Question was Asked From
Miro-Flex LED Trailer Light w/ Reflector - Brake, Turn, Tail - Submersible - Round - Red - 24V
- Trailer Lights
- Tail Lights
- Stop
- Tail
- Turn
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: What is the Difference Between the Hopkins Engager Breakaway Kit # 20099 and # HM20119
- Q&A: Replacement Pin Recommendation for Fastway Weight Distribution System
- Q&A: Is the Optronics 21 Diode LED Trailer Taillight the Brightest
- Q&A: Does Sealed, 4 Round Trailer Turn Signal and Parking Light Come with Wiring Harness
- Article: Types of Bumpers
- Q&A: Trailer Lights Available for a 24V System
- Q&A: Does Optronics LED Trailer Clearance Light MCL66A24B Need Mounting Plate
- Q&A: Comparing the ST51RB to the ST52AA for Function and Cost