How to Determine the Correct Replacement Dust Caps for a 2011 Haulmark Cargo Trailer
Updated 09/23/2014 | Published 09/22/2014
Question:
will this dust cap fit my 2011 haulmark cargo trailer? with 6 bolt drums
asked by: Den
Expert Reply:
To determine the correct dust caps for your trailer you will need to measure the inner diameter of the hub/drum where the cap fits. The measurement has to be as accurate as possible so you will need to use digital or dial calipers. If that measurement is 2.446 inches then cap set # RG04-060 will fit.
I also can most likely figure out the correct one by going by the outer bearing number. You will not have to remove the hub/drum to get the number. You should be able to see it by removing the castle nut and any washers and wiping the grease away to see the number stamped into the side of the bearing.
Product Page this Question was Asked From
Grease Cap, 2.44" OD Drive In - Qty 2
- Trailer Bearings Races Seals Caps
- Caps
- Standard Grease Cap
- 2.44 Inch O.D.
- 2.44 Inch
- 5200 lbs Axle
- 6000 lbs Axle
- TruRyde
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: How to Replace a Rubber RV Roof
- Q&A: Do You Have to Replace the Converter Section of a PD4590 Power Center For Lithium Batteries
- Q&A: Correct Replacement for Dexter 010-036-00 Grease Seal
- Article: How to Install an RV Awning From Scratch
- Q&A: What Length of Screw is Needed to Install the Solera Awning Cradle Support
- Q&A: Replacement Hub and Drum Assembly for Dexter 008-219-04
- Q&A: Recommended Replacement Brake Hubs and Brakes for a Dexter 7K Axle
- Article: Most Popular Wheel Bearings
- Q&A: Can Furrion Chill AC Unit be Installed on 1-1/2 Thick Car Hauler Trailer Roof
- Article: Trailer Lighting Requirements
- Q&A: Is Taskmaster Provider the Best Trailer Tire
- Article: Parts Needed to Add Electric Drum Brakes to a Trailer
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide