Dimensions and Mounting Grommet Recommendation for the LED Back Up Light part # BUL35CB
Published 08/12/2014
Products Featured in This Question
Question:
what are the dimensions of this light?
asked by: Udo P
0
Expert Reply:
I attached a picture of the LED Back Up Light part # BUL35CB that shows its dimensions.
If you were planning on making a grommet to install these lights you could instead just get the Grommet part # A33GB as this grommet is specifically designed to fit this light.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Optronics LED Backup Light for Truck or Trailer - Submersible - 16 Diodes - Clear Lens
- Trailer Lights
- Tail Lights
- Backup
- Rectangle
- Recessed Mount
- Non-Submersible Lights
- LED Light
- 5-5/16L x 3-7/16W Inch
- White
- Optronics
more information >
Continue Researching
- Q&A: Grease Cap Recommendation for Hub Bore of 1.96 inch
- Q&A: How to Wire Reverse Lights on a Trailer with a 4-Way Trailer Connector
- Q&A: Replacement Hub Drum for Hayes 8k Trailer Axle
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller Installation on a Ford Full-Size Van
- Article: Brake Controller Installation on a Full-Size Ford Truck or SUV
- Q&A: What Light Will Replace My Light with DOT 16P2ST2 T35 16 Stamped on it for My Truck?
- Q&A: Replacement for Discontinued Bargman 30-91-010 and 30-91-011 Tail Lights
- Q&A: Replacement Bearings and Seal for Dexter Hub 8-147
- Q&A: Can Single Wire Clearance Light Be installed To Replace 2-Wire Light On Travel Trailer
- Article: Trailer Wiring Diagrams
- Article: RV AC Not Cooling? What's Normal, What to Check, and When to Replace
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide