Replacement Breakaway Cable For Dexter DX6.6 Drop N Go Actuator
Updated 11/02/2026 | Published 10/31/2026
Products Featured in This Question
Question:
I am looking for a part for Dexter DX6.6 -N-Go Brake Actuator - Drum Brakes - 2 Ball - Zinc Plated - 6,600 lbs I am looking for a replacement brake-away cable, same as new. Can you assist?
asked by: Mike B
0
Product Page this Question was Asked From
Dexter DX6.6 Drop-N-Go Brake Actuator - Drum Brakes - 2" Ball - Zinc Plated - 6,600 lbs
- Brake Actuator
- Surge Brake Actuator
- Boat Trailer
- Construction Trailer
- Farm Trailer
- Travel Trailer
- Utility Trailer
- Bolt-On
- 6600 lbs GTW
- 2 Inch Ball Coupler
- 3 Inch Channel Tongue
- Drum Brakes
- No Lockout
- Dexter
more information >
Continue Researching
- Q&A: What Is the Best Replacement for a Dexter/Tie Down Model 660 Brake Actuator?
- Q&A: Replacement for Atwood 61101 Brake Actuator
- Q&A: Looking For Hubs, Bearings And Brakes For 2004 2-Axle Extreme Boat Trailer
- Q&A: Correct Atwood LPCO 36636 Wires to Connect to RV Propane Gas and Carbon Monoxide Detector
- Article: How to Bleed Your Trailer Surge Brakes
- Q&A: Troubleshooting Dexter DX6.6 Drop-N-Go Brake Actuator Not Fully Seating On Hitch Ball
- Q&A: Replacement Trailer Lighting and Wiring Harness for a Big Tex 70PL Utility Trailer
- Q&A: Greasable Shackle Bolt that is 3-1/2 inch Long and 9/16 inch Diameter
- Article: Slipper Spring Trailer Suspension System Review
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Hydraulic Trailer Brakes: How They Work & What to Buy
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)