What Size Hole Is Needed to Install Optronics LED Trailer Clearance and Side Marker Light # MCL52AB
Published 08/01/2014
Products Featured in This Question
Question:
Looking to purchase some of these lights. Did not see how large of a hole I have to drill in my trailer frame. Please advise.
asked by: Nick
Helpful Expert Reply:
I went out to the warehouse and pulled Optronics LED Trailer Clearance and Side Marker Light # MCL52AB to measure the back of the light. The back of the light that will fit into the hole on the trailer measures 2.27 inches so you would need a 2-1/4 inch hole. But I do recommend starting out slightly smaller just to be safe. You can always make a small hole larger but you can't make a large hole smaller.
For a pigtail to plug into this light use # A46PB.
Product Page this Question was Asked From
LED Trailer Clearance and Side Marker Light w/ Flange - Submersible - 5 Diodes - Round - Amber Lens
- Trailer Lights
- Clearance Lights
- Marker
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 2 Inch Diameter
- Amber
- Optronics
more information >
Continue Researching
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: Replacement Marker/Clearance Lights For a 2006 Ranger Trail Boat Trailer
- Q&A: Optronics Mini Red LED Clearance or Side Marker Light MCL131CR3B
- Article: Trailer Wiring Diagrams
- Q&A: Looking For Replacement For Tie Down Engineering LP70 Disc Brake Actuator
- Q&A: What is the Best Grease for Trailer Bearings
- Q&A: Replacement SA1250FO-02 Battery for Hopkins Trailer Breakaway System
- Q&A: What Is Hole Size For Mounting 2 Inch Round Trailer Lights With Rubber Grommet
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)