Dimension of Replacement Lifting Nut for Curt Heavy Duty Direct Weld Square Jack
Published 10/21/2026
Question:
What is the dimensions for the top of the shaft where the bearing sits on the thrush washer and where the angled gear sits? Thanks
asked by: Gregory H
0
Lifting Nut
(click to enlarge)
(click to enlarge)
Expert Reply:
Hey Gregory, the dimension you are looking for on the Replacement Lifting Nut for Curt Heavy Duty Direct Weld Square Jack # C93NR is 2-1/4 inches. What jack do you have that you are looking to repair?
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Lifting Nut for Curt Heavy Duty Direct Weld Square Jack
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Nuts
- Lifting Nut
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Screw and Nut for Bulldog 10K / 12K Square Trailer Jack
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Q&A: Replacement Gear Kit Instructions and Diagram for Ram 12,000 Series
- Q&A: Can I Purchase Just the Leg for My Lippert Ground Control 3.0, or do I Need the Whole Assembly?
- Q&A: How To Re-Assemble The RAM TJD-12000SP Trailer Jack
- Q&A: Replacement Front Jack for Lippert Ground Control 3.0 Leveling Systems
- Q&A: Replacement Jack Screw and Nut Kit for a 12K Bulldog Jack
- Article: Trailer Wiring Diagrams
- Article: How to Bleed Your Trailer Surge Brakes
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: How to Install E-Track in 3 Easy Steps