Availability of Mounting Frame for Furrion Chill Cube Low-Profile

Question

Question:

I am ordering the Furrion 15K Chill Cube Low Profile A/C. My roof is only 1.75inch thick. I am ordering the FACR15LPVS-PS-AM Chill Cube and the non-ducted FACT11QV3-PS-AM ADB for my installation on your web site. However, I cannot find the required C-FACR12SA-A03 mounting frame required for my 1.75inch roof thickness installation. Is it available through etrailer?

asked by: Bon S

0

Expert Reply:

Hey Bon! We do have all of the components you need for this setup, they're just listed under different part numbers than the Furrion numbers you're using.

For the non-ducted 15K low-profile Chill Cube with heat pump, we have the white # FR22TF or black # FR82TF. You'll also need the low-profile Air Distribution Box # FR38BC, which includes the remote. The mounting frame you're looking for is the Mounting Frame for Furrion Chill Cube Low-Profile Air Distribution Box # FR34FY.

What kind of RV/trailer are you installing the new Chill Cube on?

expert reply by: Robin H

0

FR38BC
(click to enlarge)

Bon

10/7/2026

I'm swapping out a Dometic Penguin II for the low profile Furrion Chill Cube 15K BTU unit in our Airstream Nest. The entire reason is that the Dometic unit is unbearably loud. The only settings seem to be bad and worse. I will likely be running the Furrion at "gear" 50 most all the time due to our small camper. I wish Furrion would make this same spec unit in a 13.5!

Robin H.

10/8/2026

@Bon I think you're going to be really happy with the Chill Cube in the Nest, especially coming from the Penguin II. Being able to run it at the 50% gear setting should be a great fit for a camper that size. With the variable speed the 15k or even the 18k standard Chill Cube wouldn't be overkill or cause constant cycling. Furrion does have a 13.5K variable-speed Chill Cube in their newer lineup, but unfortunately it isn't a low-profile unit and I'm not entirely sure when it will finally be released for aftermarket sale.

Answer 1

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...

Answer 2

Hello Sam; that is a great question! I reached out to Furrion and you will be able to use the Furrion Chill Cube #FR69TD (white) or #FR49TD (black) with your furnace. However, the remote is not capable of operating the furnace at this time. Also, we…

view full answer...

Answer 3

Hey Jon; I was actually just talking to Furrion about heat options for the Chill Cube yesterday (1/21/2025). At this time, the only way to have heat with this unit is through a furnace on a ducted setup. The Furrion Chill Cube RV AC w/ Air…

view full answer...

Answer 4

Hey Neil. The 18,000 Btu Furrion Chill Cube RV Air Conditioner item #LC34DX fits a 14-1/4" x 14-1/4" cutout which is pretty standard on RV's. If you meant to write Dometic instead of domestic then yes it'll fit in your existing…

view full answer...

Answer 5

Hey Melanie. The reason you can't find a replacement for your GE ARC15AACBL2 15,000 btu air conditioner is because they phased them out. In 2025 all RV AC systems had to change over to a new coolant called R32. This was a EPA mandated decision.…

view full answer...

Answer 6

Hi JD; the Furrion Chill Cube #FR49TD air distribution box has a vent on it you can open and close. See the picture attached below. When it is closed it forces more of the air through the ducted system. Assuming you have a ducted system you will need…

view full answer...

Answer 7

Hey Matt, Furrion typically has 4 wires running to their thermostats and the Chill Cube Thermostat #LC74DX is no exception. The harness you see with the thermostat would plug into the Chill Cube's controller and has 4 wires to extra wire to to…

view full answer...

Answer 8

Hey Kyle! That is correct. The Coleman-Mach Mach-C Everest has variable-speed cooling and an inverter-driven compressor. However, the Mach-C Everest uses a traditional wall thermostat instead of a remote control. It also works with both ducted and…

view full answer...

Answer 9

Welcome back David! I definitely concur with Duane! That was an interesting video. The Furrion Chill Low-Profile AC with Heat Pump item #FR82TF in black and item #FR22TF in white aren't even out yet for purchase so he's got way more…

view full answer...

Answer 10

Hi Wayne! The Air Distribution Box - Furrion Chill Cube Variable Speed Low Profile AC - 13.5K/15K - R32 #FR38BC is only compatible with Furrion Chill Cube 13.5K and 15K low-profile variable speed air conditioners. It is not compatible with the…

view full answer...

Answer 11

Hello Michael, Sorry for the delay in getting an answer, but I am currently waiting for the information myself. As you can see this is a new item that is available for preorder, so we do not have much information about the unit. I will let you know…

view full answer...

Answer 12

Hey Michael, you'd instead want the Furrion Chill Low Profile part #FR79TQ which comes with the needed install kit that includes the controller, air box, and thermostat. The part #FR99TQ that you referenced only includes the upper unit. Are you…

view full answer...

Availability of Mounting Frame for Furrion Chill Cube Low-Profile

Products Featured in This Question

Product Page this Question was Asked From

Continue Researching