bing tracking image
Q & A Icon

What Hardware Is Needed To Install The Dome Assembly for Ventline Trailer Roof Vent BVD0449-A01  

Updated 10/09/2026 | Published 10/05/2026

Question:

Need hardware for roof vents cover I purchased from you

0

Expert Reply:

Hey Kirby, thanks for reaching out. The Ventline Replacement Dome # BVD0449-A01 does not require any new mounting hardware. It uses the existing hinge on the roof vent and basically slides/snaps onto that hinge, then the existing lift-arm assembly gets reattached using the two screws already on your vent. A Phillips screwdriver is all you need for the swap.

If your existing lift-arm screws or operator are missing or damaged, the replacement operator, knob, and screw assembly is # BVD0462-00. Otherwise, the dome itself installs using the hardware already on the Ventadome.

What rig are you outfitting?

expert reply by:
0
Jesse M
Replacement Operator, Knob and Screw for Ventline Ventadome Trailer Roof Vents w/ Wedge-Shaped Dome
Replacement Operator, Knob and Screw for Ventline Ventadome Trailer Roof Vents w/ Wedge-Shaped Dome
(click to enlarge)
Dave K. profile picture

Dave K.

10/7/2026

I actually never installed it because we bought a new camper and sold the one I bought the vent dome for. I gave it to the new owner. Installation looked to be pretty straightforward, I didn’t get to it.

Joe profile picture

Joe

10/7/2026

Easy to do. Just be careful with any of the old plastic trim. Mine was all really super brittle due to sun exposure. I ended up replacing an inner sleeve thing around the screen too.

Ronnie B. profile picture

Ronnie B.

10/9/2026

I experienced the same with the installation. Very simple. I also replaced the sleeve on one of mine and I replaced the screen on two of mine, very simple.

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>