Will Replacement Idler Head Slip Ring Assembly Fit Solera Regal Style Head
Updated 10/07/2026 | Published 10/03/2026
Question:
I have a solara power awning that has the regal style covers. Will this work with those covers?
asked by: Blake
0
Expert Reply:
Hey Blake, welcome back! Yes, the Replacement Idler Head Slip Ring Assembly # LC330961 will work with the Regal-style covers as long as your Solera power awning already has the LED lights on the roller tube.
What kind of trailer are you working on?
expert reply by:
Robin H
0
Idler Head Slip Ring Assembly
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Replacement Idler Head Slip Ring Assembly for Solera Power RV Awnings w/ Roller Tube LEDs
- Accessories and Parts
- RV Awning
- Head Parts
- Hardware
- Solera Replacement
- Slip Rings
- Lippert
more information >
Continue Researching
- Q&A: How To Replace Bent Shaft On Solera Power Awning Head
- Q&A: How to Remove and Reinstall New Pin Solera Pin LC93FR
- Q&A: Can the Lend-A-Hand Banister Handrail Be Installed on Trailers with Corrugated Siding?
- Q&A: Replacement Black Regal Cover For Solera RV Awning
- Q&A: Replacement Toilet for a Aqua-Magic Style II 42070
- Q&A: Looking For Replacement Drive Head Pin And End Cap For Solera 2000 Regal Style Power Awning
- Q&A: Replacement For A Solera Awning Idler Head With A Bent Pin
- Article: Best Bike Racks for Electric Bikes
- Article: Ram Trailer Tow Prep Package
- Article: How to Install an RV Awning From Scratch
- Article: Installing an Electric Brake Controller on 2007-2013 GM Full-Size Truck or 2007-Present GM SUV
- Article: Beginner's Guide to RV Awnings: How to Open, Close, and Maintain Your Awning
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
Greg G.
10/6/2026
When I purchased my RV the wires connecting the power to the slip ring were broken, the point contact was bad and the electrical band around the ring was bad also. I had to jerry rig the wiring to be able to use the lights in my awning. I bought the Idler head from etrailer, the part took care of all of my issues and have been resolved. Now I just flip the light switch and I have light. The install was quite easy and I did it by my self. I used two folding ladders to do the job. One was to stand on and the other was to place the extended awning on. I just popped off the awning, laid it on the top of the ladder. Then I removed a couple of bolts/screws, slid the new unit into place and installed the awning. DONE, easy peasy.