Replacement Venture Landing Gear Follow Leg for Passenger Side
Updated 09/27/2026 | Published 09/26/2026
Products Featured in This Question
Question:
I have a Venture Mfg LCI PN 142178, ser no 9000-348017 Landing Gear passenger leg that has blown out the screw nut threads that the jack screw screws into. Is that a replaceable component? It is on a Genesis Vortex 2815VT
asked by: Chuck S
(click to enlarge)
Expert Reply:
It sure is Chuck and thanks for the picture. The Lippert Venture Follow Leg Repair Kit for 5th Wheel RV Landing Gear item # LC146060 is the correct one for your Venture landing gear follow or passenger side leg.
The item # LC146060 kit includes 1 follow drive shaft, 2 drive shaft bushings, 1 E-clip, 1 drive pin, 1 spiral pin, 1 12T bevel gear, 1 16T bevel gear, and 1 shim washer.
The housing of your landing gear leg looks pretty bent up from the picture you sent. If the Repair Kit item # LC146060 doesn't get it back up and running, you'll need to replace the follow leg on your Venture landing gear with one of the following replacement legs. To ensure you get the correct leg you will need to measure the length of the outer black portion of the leg.
The Replacement Follow Leg item # LC119101 has an outer tube length of 29-1/2".
The Replacement Follow Leg item # LC64PJ has an outer tube length of 33-1/2".
How did your landing gear leg get damaged? Feel free to answer this and throw in any other questions you have, where it says Add Comment.
(click to enlarge)
(click to enlarge)
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Lippert Venture Follow Leg Repair Kit for 5th Wheel RV Landing Gear
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Hardware
- Repair Kit
- Lippert
more information >
Continue Researching
- Q&A: Schematic Diagram for Stromberg Carlson Lead Jack Repair Kit LG-146059
- Q&A: How to Find the Correct Replacement Lead Leg for 5th Wheel Landing Gear
- Q&A: Replacement Parts or Assembly for Landing Gear of 1998 Gulfstream Innsbrook
- Q&A: Keystone Montana Landing Gear Legs Turn but Won't Retract/Extend
- Q&A: Replacement Landing Gear Motor for a 8532-07 Motor
- Q&A: 5th Wheel Landing Gear Kit to Replace Atwood
- Q&A: Replacement gears for Lippert Landing Gear Instructions and Diagram
- Article: Brake Controller Installation: Starting from Scratch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Install an RV Awning From Scratch
- Article: Testing Trailer Brake Magnets for Proper Function
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
Chuck S.
9/27/2026
The RT angle gears are fine. It is the clamped in (captured nut) nut that the screw goes into that stripped out.. I have ordered a rod coupler nut that I am going to weld and replace the stripped out capture nut.