Indicator Light Staying Illuminated on Demco Air Force One
Updated 08/12/2026 | Published 08/08/2026
Products Featured in This Question
Question:
Changed reed switch and light stays on what should I check now.
asked by: Garry B
Expert Reply:
Thanks for your question Garry. If you replaced the # DM65MV on your Demco Air Force One and the indicator light is staying on, I would make sure the actuator cylinder is fully returning when the brake pedal is released. If the cylinder is getting hung up, the magnet may not be returning to the correct position. You may also need to adjust the reed switch itself up or down the cylinder to ensure the magnet is not misaligned.
Are you having issues with the # DM23MV you previously purchased?
Product Page this Question was Asked From
Replacement Reed Switch with Mounting Strap for Demco Air Force One Flat Tow Brake System
- Accessories and Parts
- Flat Tow Brake System
- Switches
- Demco
more information >
Continue Researching
- Q&A: Will Replacement Reed Switch DM65MV Work With Demco Air Force One DM55MV?
- Q&A: Light Kit For Air Force One Supplemental Braking System
- Q&A: Replacing A-Frame Surge Brake Actuator On 1966 Scotchman Camper
- Q&A: Tire and Wheel Size to Replace 18.5x8.5-8 on Trailer
- Q&A: Trailer Tire Size to Replace 8.75R16.5 Tires
- Article: Must-Have Flat Towing Components
- Q&A: Towing Lights that Bypass the Tow Vehicle's Wiring and Are NOT Magnetic
- Q&A: What is Amperage Draw of Demco LED Light Bar for Towed Vehicles DM36MV
- Article: Brake Controller Installation: Starting from Scratch
- Article: Flat Towing Package for 2014-2018 Jeep Grand Cherokee
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box