bing tracking image
Q & A Icon

Troubleshooting TST TPMS Sensors Disconnecting and Reconnecting  

Updated 07/23/2026 | Published 07/08/2026

Products Featured in This Question



Question:

I finally got the Product Qty Total TST-507-INT-6-C TST TPMS - Color Display - Signal Booster - 6 tpms all hooked up and installed the fm antenna in middle of my 32’ motorhome and it seems to connect and disconnect all the time see attached photos I am very disappointed with the amount money of this kit are there stronger fm antennas? Please let me know

0

Expert Reply:

Hi David,

The antenna for TST TPMS system part # TST-507-INT-6-C should be able to easily handle a 32' long motorhome. TST recommends mounting it as closely to the rear of the motorhome as possible, ideally in a rear storage compartment or the battery compartment against the exterior wall. If the repeater is near the middle or front of the motorhome could reduce its effectiveness. The repeater also needs to be wired directly to a 12V source, so it has constant power while driving. The red light should remain on or sometimes blinking when transmitting even while driving.

I would try relocating the repeater towards the rear of the motorhome and double checking that it's hooked up to a consistent 12V source.

Do all six sensors disconnect or just a few of them?

expert reply by:
0
Claire H
Hakan R. profile picture

Hakan R.

7/23/2026

I installed the repeater antenna in the middle of our 25' RV, on a 12 V circuit, with a manual on/off toggle switch to prevent draw while parked. Our system works fine with or without the sensor turned on! I conclude that the signal from the tire sensors to the color display is strong enough as is - without the antenna. I have never lost connection with any tire sensor, now 18 months since installation. I recommend verifying that the display unit has a solid, strong enough 12V power supply.

Claire H. profile picture
Etrailer Expert

Claire H.

7/23/2026

@HakanR Thanks for sharing your experience! It sounds like you've got a well-thought-out setup. On a 25' RV, it's certainly possible for the display to maintain a strong signal without the repeater, so it's not unusual that your system works well either way. Your suggestion to verify the display has a solid 12V power supply is a great troubleshooting tip, especially for anyone experiencing intermittent sensor communication. We appreciate you taking the time to share what's worked for you!

Product Page this Question was Asked From


Q & A Icon

Continue Researching

See More Q&A Expert Answers >>