Which Adjustable 2 Ball Mount Is Best For 2022 Silverado 1500 Pulling Different Size Trailers
Published 06/23/2026 >
Products Featured in This Question
Question:
I have a 2022 Silverado 1500 with the factory 2 inch receiver, and I tow a small utility trailer with a 2 inch coupler and a camper with a 2-5/16 inch coupler. Would the Fastway Flash Force be a good way to stop carrying two different ball mounts? Right now I have the Curt ball mounts that I swap since they have one ball on each mount.
asked by: Dale
Expert Reply:
Good morning Dale! Yes, that’s exactly the kind of setup where the Fastway Flash Force Adjustable 2-Ball Mount # FA33FR or # FA93FR makes a lot of sense. Both fit a 2" x 2" receiver and include both a 2" hitch ball and a 2-5/16" hitch ball, so you can rotate the ball assembly instead of swapping the whole ball mount each time.
The main thing is choosing the right drop range. The # FA33FR gives you up to 5" of drop and 5-1/2" of rise, while the # FA93FR gives you up to 7" of drop and 7-1/2" of rise. If your truck and trailers sit fairly close to level already, I’d lean toward the # FA33FR because it gives you a useful range without hanging down as far. If one of your trailers sits lower, or your truck is lifted or just sits higher at the hitch, the # FA93FR gives you more adjustment to work with.
Capacity-wise, both 2" receiver versions are rated for up to 8,000 lbs with the 2" ball and 10,000 lbs with the 2-5/16" ball, so just make sure your loaded trailer weight and the rest of your towing setup stay within those ratings and of course under your truck's tow rating. Also I would add a lock pin kit for added security with # FA86-00-3685. This has one pin that goes in the receiver hole, and the second pin replaces one of the original pins on the ball portion to keep it secure.
Dale, if you can measure from the ground to the inside top edge of your receiver and then from the ground to the bottom of each trailer coupler while the trailers are level, I can help you pick between the 5" and 7" drop versions.
Product Page this Question was Asked From
Fastway Flash Force Adjustable 2-Ball Mount- 2" Hitch - 5" Drop - 5-1/2" Rise - 10K
- Trailer Hitch Ball Mount
- Adjustable Ball Mount
- Two Balls
- 2 Inch Ball
- 2-5/16 Inch Ball
- Steel Shank
- Drop - 5 Inch
- Rise - 5 Inch
- Fits 2 Inch Hitch
- 10000 lbs GTW
- 8000 lbs GTW
- Fastway
more information >
Continue Researching
- Q&A: Is there an Anti-Rattle Device for a Fastway Flash Force Adjustable Ball Mount?
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: How to Measure for Trailer Hitch Drop
- Q&A: What Is Needed to Allow a Trailer to be Towed Level
- Q&A: How To Prevent Theft And Rattling Of Fastway Flash Force Adjustable Drop Hitches For Truck Receiver
- Q&A: Is There A Way To Lock The Fastway Flash Force Ball Mounts So They Can't Be Stolen Off My Truck?
- Q&A: Why Would a Trailer Hitch Come Detached From the Ball During Travel?
- Q&A: Where is Drop Dimension Measured on Curt Hitch # C87CR
- Q&A: Storage Cover Recommendation for Furrion Chill RV AC Unit
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Steel vs. Aluminum Ball Mounts
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Install a Brake Controller on Chevrolet / GMC 1999-2006 Pickups
- Article: 5 Things to Know About Weight Distribution Hitches

