How Long Is The Fish Bolt Wire That Comes In Torklift GlowStep Scissor Steps # TLA7833?
Updated 05/28/2026 | Published 05/24/2026
Question:
How long is the bolt fish wire that comes with the install equipment?
asked by: Jonathan G
0
Expert Reply:
Good morning Jonathan.
I went out to the warehouse and measured for you. The fish wire for installation in the TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear - 3 Steps - 375 lbs - Black Bracket # TLA7833 measures 36" in length. It appears to be about 3/8" diameter for a 3/8" or similar size bolt. Hope this helps!
Did you loose it in your kit or were you just asking? And What camper is this going on?
expert reply by:
Andrew N
0
Product Page this Question was Asked From
TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear - 3 Steps - 375 lbs - Black Bracket
- RV Steps
- Truck Camper
- Snap-On Step
- 20 Inch Wide Step
- 23 Inch Wide
- 3 Steps
- 7-1/2 Inch Drop/Rise
- 24 Inch Entry
- 25 Inch Entry
- 27 Inch Entry
- 29 Inch Entry
- 31 Inch Entry
- 33 Inch Entry
- 34 Inch Entry
- Aluminum
- TorkLift
more information >
Continue Researching
- Search Results: torklift landing gear
- Search Results: shower head
- Search Results: rv refrigerators
- Search Results: propane switch
- Search Results: usb outlet
- Search Results: rv transfer switch
- Video: Review of PowerMax RV Power Converter - Converter and AC/DC Panel - PM47VR
- Shop: RV Interior Lighting
- Shop: BTBRV Magnetic Hitch Receiver Reducer Set - 3" to 2-1/2" & 2-1/2" to 2"
- Q&A: Need Converter For 1996 Lance Camper With Progressive Dynamics PD4135K
- Q&A: Recommended Scissor Steps for Truck Camper
- Shop: Norcold Polar N7X RV Refrigerator - 7 Cu Ft - AC/LP
- Shop: TorkLift GlowStep Stow N' Go Scissor Steps w/ Landing Gear - 3 Steps - 375 lbs - White Bracket
- Shop: PowerMax 30A RV Power Center and Distribution Panel - 55A DC Converter
- Shop: PowerMax 30A RV Power Center and Distribution Panel - 45A DC Converter
- Shop: WFCO Auto Detect RV Converter and AC/DC Distribution Panel - 12V - 25 Amp
- Shop: Leg Extensions for TorkLift GlowStep Scissor Steps w/ Landing Gear
- Search Results: torklift step
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Video: Replacement Dome Assembly for Ventline Ventadome Trailer Roof Vent Spec Review
- Article: Trailer Wiring Diagrams
- Shop: Trailer Hitch
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Q&A: Can Furrion Chill Cube Operate With RV Furnace
- Shop: Trailer Wiring
- Article: Trailer Lighting Requirements
- Video: Furrion Chill Cube RV Air Conditioner Review and Installation - Travel Trailer Edition
- Shop: Suspension Enhancement
- Q&A: Replacement Option For Norcold N306.3 RV Fridge
- Q&A: Best Replacement For Norcold N611 RV Refrigerator
Explore Expert Info
![Our Expert]()
on RV Steps
on RV Steps
Jonathan G.
5/28/2026
Thank you, sir. I’m looking to install on the bumper of an older model Lance truck camper. So I’m trying to figure out if that fish wire will be long enough based on where I’m installing it because I will need it to reach the very end of the bumper. Can you also confirm that a step can be added to the 3 step set? Based on everything I’ve seen, the 3 step should suffice, but it could be borderline. I know they sell a 6” extension for the landing gear, but after using it if I need a 4th step I’d like the option to add one.