Length of the Replacement Stand-Off Brace # SPN-416
Updated 07/15/2014 | Published 07/13/2014
Question:
What is length of this standoff tube, I am looking for 8
asked by: Chuck A
0
Expert Reply:
I went out into our warehouse and measured the Replacement Stand-Off Brace # SPN-416 and found that it measures 5-1/2 inches. This is the only standoff tube we offer at this time.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Standoff for Surco Exterior RV Ladders - Qty 1
- Accessories and Parts
- RV Ladders
- Support Peg
- Surco Products
more information >
Continue Researching
- Shop: Replacement Standoff for Surco Exterior RV Ladders - Qty 1
- Shop: Replacement Standoff for Stromberg Carlson Exterior RV Ladders - Qty 1
- Q&A: Ladder Standoff Replacement with Square Base
- Search Results: screws
- Q&A: Availability of a Replacement Control Board For a Dometic 991762494 Dual Zone
- Q&A: What is Length of Stromberg Carlson Stand Off SCS44SR
- Q&A: Replacement Fan Motor Assembly for Fan-Tastic Vent Model 2000RDM
- Q&A: If the Stromberg Carlson RV Ladder Was Not Installed Into Studs Is It Safe To Use?
- Q&A: What Does Roll Pin Look Like on Replacement Ladder Rung
- Article: How to Drain an RV Water Heater
- Q&A: Replacement GE Air Conditioner for a ARC15AACBL2
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: Can You Flat Tow a Ford Escape?