Size of Hole Needed to Install Roadmaster Bulb and Socket Kit # RM-155 In Taillight Assembly
Updated 07/15/2014 | Published 07/13/2014 >
Products Featured in This Question
Question:
how big of a hole do I have to drill to mount these lights in my taillight housing ? thanks rm-155-2
asked by: Jesse P
Expert Reply:
To use the Roadmaster Bulb and Socket kit you referenced, part # RM-155-2, you'll need to drill a 1 inch diameter hole in the rear of your taillight assemblies. You'll want to make sure you have at least 2-1/2 inches of available depth, because if the bulb is too close to the inside of the lens, the lens could melt.
The full kit that includes the connectors and wire is part # RM-155.
I'll link you to an install video that you should find helpful.
Product Page this Question was Asked From
Roadmaster Bulb and Socket Set for Tail Light Wiring Kits - Incandescent - Qty 2
- Flat Tow Wiring Harness
- Bypasses Vehicle Wiring
- Bulb and Socket Kit
- Universal Fit
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Replacement Motor for Klauber Slide Out Motor K01431B300
- Q&A: Replacement Klauber A-300 Motor For RV Slide Out.
- Q&A: Replacement Control Module For Control Module 346005 On 6-Point Lippert Ground Control
- Q&A: Can the Furrion Chill Cube Be Used to Replace a Ducted Dometic AC
- Q&A: Will Blue Ox Bulb and Socket Tail Light Wiring Kit for Towed Vehicles Work on My 2024 Jeep Gladiator
- Q&A: How to Wire the 4-Way Round Socket for the Blue Ox 7-Wire to 4-Wire Adapter # BX88254
- Q&A: Replacement Thermostat for Dometic 3316410.012
- Article: Diode Installation Instructions for a Dinghy with Separate Tail Light Wiring
- Article: Trailer Wiring Diagrams
- Article: Tow Bar Wiring: Which Wiring Kit is for You?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: Flat Towing Package for 2012-2014 Honda CR-V



