Replacement Parts for Kwikee 42 Series Electric RV Steps
Updated 05/06/2026 | Published 05/02/2026 >
Products Featured in This Question
Question:
I would like to know if I can buy parts for your 42 series RV step without purchasing the entire step.
asked by: Bruce R
0
Expert Reply:
Hey Bruce! The only replacement part available for the 42 series is the Replacement Motor with Box Brackets for Kwikee 42 Series Electric RV Steps # LC369473. Which parts were you looking for?
expert reply by:
Robin H
0
Product Page this Question was Asked From
Replacement Motor with Box Brackets for Kwikee 42 Series Electric RV Steps - 12V
- Accessories and Parts
- RV Steps
- Motors
- Kwikee
more information >
Continue Researching
- Video: Review of Lippert Kwikee Replacement Top Step Ball Bearing Slides - LC97WD
- Shop: Replacement Top Step Ball Bearing Slides for Kwikee 42 Series Electric RV Steps - Qty 2
- Shop: Replacement Upper or Lower Slide Assembly for Kwikee 47 Series Electric RV Steps
- Shop: Replacement Upper Slide Assembly for Kwikee 42 Series Electric RV Steps
- Video: A Closer Look at the Motor Upgrade Kit for Kwikee 42 Series Electric RV Steps
- Shop: Motor Upgrade Kit for Kwikee 42 Series Electric RV Steps
- Q&A: Replacement Gear Arm Assembly For Kwikee Series 42 Steps
- Q&A: Recommended 12v Refrigerator Replacement For A Norcold 1210 RV Refrigerator
- Q&A: Replacement Gear, Motor, and Controller for Series 42 Kwikee Steps
- Q&A: Replacement Gear for Kwikee Steps 9010000220 On Fleetwood Bounder Motorhome
- Q&A: Troubleshooting Kwikee Series 42 RV Steps That Won't Fully Retract
- Q&A: Replacement 003-30 Tail Light For A 2019 Coachmen Freelander
- Q&A: Where Is The Kwikee Replacement Entry Step Gear LC369354 Made?
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Printable Trailer Bolt Hole Pattern Template



Debbi S.
5/6/2026
Bruce, we have a 2006 American Eagle with the 42 series step. After 20 years of frequent use, the teeth on the rotating arm were so worn we needed to replace more than just the motor. We replaced the "Replacement Motor with Box Brackets" from eTrailer. If you can lift your RV to provide adequate clearance it is a relatively simple replacement. We loosened the electrical connection to the motor to control the arm to rotate to a position that would allow access to the four nuts that you remove.