How to Use a B&W Companion 5th Wheel Hitch w/a Square Receiver in the Ford Factory Puck System
Updated 04/20/2026 | Published 04/14/2026
Products Featured in This Question
Question:
I have a BandW sliding companion hitch that was installed on my 2021 F250 Super duty with a BandW turn over ball kit. Truck was replaced with a 2026 F250 Super duty that has the factory installed fifth wheel hitch prep kit. can I use my existing hitch in the new truck ?
asked by: Bob P
Expert Reply:
Congrats on the new truck Bob! You can reuse the head on your B&W Companion item # BWRVK3400, however you are going to have to replace the base. There's no way to convert your current base with the square receiver to work with the puck system.
For another sliding Companion base, you'll need the Replacement Slider Base for B&W OEM 5th Wheel Trailer Hitch item # BWRVB3370.
For a fixed base, you'll need the Replacement Base for B&W Companion OEM 5th Wheel Trailer Hitch item # BWRVB3300.
Both of these bases are going to drop right down into your new truck's factory puck system. They will give you a 20,000 lbs towing capacity.
What kind of 5th wheel trailer do you have and how long is the bed in your new truck?
You can add this information, along with any other questions you have, where it says Add Comment.
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Replacement Slider Base for B&W OEM 5th Wheel Trailer Hitch - Ford Towing Prep Package - 20K
- Accessories and Parts
- 5th Wheel Hitch
- Slider Parts
- 20000 lbs GTW
- Slider
- Companion
- 12 Inch Fore/Aft Travel
- B and W
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended Gooseneck Ball for the Ford Factory Puck and Gooseneck Systems
- Article: Trailer Wiring Diagrams
- Q&A: Will The B&W Companion Fit Ford F350 Factory Pucks?
- Q&A: B&W Companion Slider Base That Fits 2020 Ford F-350 Super Duty With Factory Prep Puck System
- Q&A: Looking For 5th Wheel/Gooseneck Wiring Harness For 2018 GMC Sierra 2500 With 6-1/2' Bed
- Q&A: How to Gain Additional Height With Curt 5th Wheel Hitch at Max Height Setting
- Q&A: Will Towing Nose High Cause Tire Wear Problems and How to Fix a Nose High 5th Wheel Trailer
- Q&A: Solar Panel System And Inverter Needed For A 2021 Keystone Cougar 5th Wheel With Zamp Solar Inlet
- Article: Can You Flat Tow a 2025 Cadillac Escalade?
- Article: Fifth Wheel Trailer Hitch Information and Installation Tips
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
Dale
4/20/2026
Bob, I had a similar issue when I traded my 2016 with a Companion for my 2021 with the puc system. I first purchased the Ford hitch but quickly found out i could not adjust it high enough to get save bed rail clearance. Since I had the Companion still, I called Etrailer and they hooked me up with a slider base for my existing plate. Love this setup because of lots of adjustment in it. Towed 13000 plus mile to Alaska and back without issue. I also use it for my deck over with king pin rather than take it out. It is a very heavy setup for sure, but it is built. The slider makes life with a short bed much easier. Hope this helps.