Roadmaster Rear Sway Bar Compatibility with Rear Track Bar on 2015 Fleetwood Flair V10
Updated 04/12/2026 | Published 04/02/2026 >
Question:
Will the roadmaster sway bar for my 2015 Fleetwood flare V 10 interfere with my rear track bar?
asked by: Bill T
Expert Reply:
Hi Bill, that’s a really good question and you’re right to think about how those parts interact before adding anything new. A rear sway bar and a rear track bar usually don’t mount in the exact same spot, but they do share the same general area around the axle and frame and each one is doing a different job.
The Roadmaster sway bar part # RM-1139-146 helps control body roll side to side, while the track bar keeps the axle centered under the coach. From what Roadmaster has told us, their sway bar typically mounts a bit further toward the rear of the axle, while most track bars sit a little more forward, so in many setups they can work together without issue. That said, there are enough variations in brackets and designs that I wouldn’t want to promise clearance without taking a closer look.
If your track bar is aftermarket, the brand and model will help me verify fitment, and if it’s factory, a quick photo of how it’s mounted will let me check for any potential interference so you don’t end up with contact, noise, or premature wear.
Where do you usually take your Flair most, out on windy interstates or up through mountain grades?

Kurt
4/8/2026
I installed the additional Roadmaster rear trac bar on my 2013 Winnebago Vista 27N and it went on without any issues, I also changed out the front sway bar to the larger Roadmaster, and it also went on without any issues. My RV is 18K on F53 Frame, I also added a sway bar on the rear, I just had my front end aligned with the front wheel bearings repacked and installed the roadmaster steering stabilizer. It has helped very much. I am thinking about adding the front trac bar and I think I would be complete with about all the improvements I can make.


Product Page this Question was Asked From
Roadmaster Rear Anti-Sway Bar - 1-1/2" Diameter
- Anti-Sway Bars
- Anti-Sway Bar
- Rear
- 1-1/2 Inch Diameter
- Fixed End Link
- No Drilling Required
- Mounting Hardware Included
- Roadmaster
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Replacement Control Panel for Lippert Ground Control 3.0 and Travel Trailer RV Leveling System
- Shop: Replacement Lippert Control Panel with Amp Connector for 4-Point Leveling System
- Video: Review of Lippert Components Trailer Jack - Camper Jack - LC175225
- Q&A: Replacement SnapPad for Lippert 9" Round Feet on 2019 Thor Freedom Traveler A30
- Q&A: Recommended Anti-Sway Bar, Steering Stabilizer, and Air Bags for 2018 Thor ACE 30.3
- Q&A: Air Force One Air Jumper Kit For Spartan K2 Chassis.
- Q&A: Flat Towing Vs. Using a Tow Dolly for Jeep Wrangler
- Q&A: Can Sumo Springs for Motorhome Be Installed Without Removing Rear Wheel
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Q&A: Installation Time for Demco Tabless Base Plate Kit on Ford Maverick
- Q&A: Recommended Replacement for Shurflo 4008-101-A65
- Article: Stability Control for Heavy Duty Vehicles
- Article: Flat Towing Package for 2015-2018 Chevrolet Silverado 2500
- Article: How to Install an RV Awning From Scratch
- Article: How to Winterize & De-Winterize Your RV (Simple Guide)
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Must-Have Flat Towing Components


Curt
4/8/2026
The extra rear sway bar I added does not interfere with my track bar on my 2015 Storm. Which is similar to the Flair.