Replacement Press In Wheel Studs For A 7k Dexter Axle 9/16” - 18 2" Long
Updated 03/24/2026 | Published 03/21/2026 >
Products Featured in This Question
Question:
I need press in lugs for a 7k Dexter axle with disk breaks from a 2022 Grand Design Solitude GK310. The lug threads are bad but it is a 9/16” - 18tpi x 2”long from the end of the threads to the inside of the head. Please help. This is an 8 lug wheel and again, it has disk breaks, not drum. Thank you, Scott
asked by: Scott M
Expert Reply:
Hey, Scott. Happy to help.
We have exactly what you need. The Trailer Hub Wheel Stud # 7-223 is 2" long from the bottom of the bolt head to the end of the threads and has the 9/16"-18 thread you’re looking for. These studs work with both drum and disc brakes.
I’ve included a picture of all the specs below as well:
A - 9/16" thread diameter
B - 2" stud length
C - 0.31" spline length
D - 0.75" base length
E - 0.69" spline diameter
What trips are you prepping your Solitude for?

Scott M.
3/24/2026
Thank you, I have been able to source them locally. We had planned a 5 week trip to Utah until diesel went north of $5/ gallon

Product Page this Question was Asked From
Trailer Hub Wheel Stud, Drive-In, 9/16" x 2" - Qty 1
- Accessories and Parts
- Boat Trailer Wheels
- Trailer Hubs and Drums
- Trailer Tires and Wheels
- Wheel Studs
- 9/16 Inch Diameter
- Drive-In Stud
- 2 Inch Long
- Redline
more information >
Continue Researching
- Q&A: Are Bearings Already Installed On TruRyde Trailer Hub and Drum Assembly
- Q&A: What Size Bearing Buddy to Replace 2-7/16-Inch Grease Cap
- Q&A: Stainless Steel Disc Brake Kit Compatible with Magic Tilt Trailer
- Q&A: Stainless Steel Disc Brake Setup for Tie Down Engineering 3500 lb Axle
- Q&A: Replacement Brake Pad and Rotor for Kodiak Stainless Steel 10" Disc Brake Kit
- Q&A: What Brake Pads Does Kodiak Disc Brake Kit # K2R35S Come With
- Q&A: Repair Kit for Fulton Gooseneck Coupler Head
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Printable Trailer Bolt Hole Pattern Template
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: How to Replace Trailer Leaf Springs in 5 Steps
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Brake Controller Installation: Starting from Scratch



Mike L.
3/24/2026
I purchased several to have as spares because I knew sooner or later the original would strip out. I no longer have that fifth wheel and let the lugs go with the trailer when I traded it in. I will say etrailer has never let me down. They know their products.