Availability of 4-Way to 7-Way With 10 Gauge Wire for Power and Ground
Updated 03/23/2026 | Published 03/19/2026 >
Products Featured in This Question
Question:
Do you have a 4-way to 7-way converter kit that uses 10AWG wires for the +12V and GND?
asked by: eric k
Expert Reply:
Hi Eric; the only pre-wired adapter with 10 gauge was made by Hopkins and they just shut down about a month ago. If you really want to have 10 gauge power and ground you will have to put it together yourself. You can use the Pollak Black Plastic, 7-Pole, RV Blade-Style Trailer Socket # PK12-707E along with the Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers # 5506.
You will hardwire your existing 4-way into the connector, then use the 10-2 wire from the wiring kit for the rest. This comes with 25' of wire so you can run the power and brake output, then use some of the leftover wire for the ground. If you don't think that will be enough (not sure what vehicle this is or how long it is) you can pick up additional 10 gauge wire # 10-1-1.
Is there a specific reason you need 10 gauge? What are you setting up?

Troy
3/22/2026
I would run a marine battery, and have the DC to DC charger pull off that Generally the fuses for the + wire on 7 way are 20 amps. Then run a 12ga wire from 7 way + to battery to maintain battery.
Product Page this Question was Asked From
Pollak Black Plastic, 7-Pole, RV Blade-Style Trailer Socket - Vehicle End
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- 7 Blade
- Plug Only
- Pollak
more information >
Continue Researching
- Q&A: How To Tow a Gooseneck Trailer with Brakes Using a Semi Tractor
- Q&A: How to Make an Adapter to Go from Semi Truck 7-Way Round to RV Style 7-Way Blade on Trailer
- Q&A: Do You Have a 2-inch Square Axle Rated for At Least 3,000lbs and Has Idler Hubs?
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams
- Q&A: Replacement Lippert 368446 Motor Needed for Front Slideout on a 2014 Jayco Motorhome
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: What Trailer Wiring do I Need for My 2020 Highlander without Factory Tow, with Connectors?
- Q&A: Replacement Brake Assemblies for Dexter 023-358-00 Trailer Brakes
- Q&A: Wear Sleeve For A 3500 Pound Dexter E-Z Lube Axle On A Travel Trailer
- Article: How to Choose the Right Trailer Hitch Class
- Article: Flat Towing Package for 2008-2011 Honda CR-V
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: The Definitive, Step-by-Step Flat Towing Setup Guide



Eric K.
3/22/2026
Need to be able to supply about 20A to the trailer to run the DC-DC converter for charging a LIon battery.