Can I Use My Goal Zero L500 Lithium Power Supply with the PowerMax 30A RV Power Center?

Question

Question:

I have a goal zero l500 lithium power supply. Will the power max 30 amp rv power center be compatible with it

asked by: Anthony m

0

Expert Reply:

Hello Anthony,

I really wish you could, but the PowerMax 30A RV Power Center and Distribution Panel with 45A DC Converter # PM47VR is not directly compatible with your Goal Zero L500 in the way most people hope.

The PowerMax converter is designed to charge a traditional 12-volt RV battery bank, whether lead-acid or lithium, that is wired directly into an RV electrical system. A Goal Zero L500, however, is a self-contained portable power station with its own internal battery management system and specific charging requirements. It is not meant to function as a direct replacement for a hard-wired RV house battery.

You should not connect the 12-volt output from the PowerMax converter directly to the Goal Zero expecting it to charge properly. The charging profiles and current limits are different, and doing so could cause improper charging or potential damage.

Instead you will want to use a battery like the Go Power Sun Cycle Advanced Lithium RV Battery - LiFePo4 - Bluetooth - Group 24 - 12V - 100 Amp Hour # GP99QR.

What kind of RV is this going in? Do you do a lot of boondocking? Any fun adventures you are looking most forward to this year?

expert reply by: Kate F

0

Anthony M.

2/20/2026

I am converting a 5x10 utility trailer into a toy hauler for my Adventure Motorcycle. I will be doing a fair amount of boondocking and was recommended to get the goal Zero 1500. Apparently, if I understand your response, I will need a deep cycle battery bank and an inverter or one of the combo power boxes specifically to power the 12 volt accessories. I would assume the goal zero will provide electricity outside of the trailer? Or would I be able to plug the goal zero into the external 20 amp plug of the trailer? I plan on having 30 amp and 15 or 20 amp external plugs. Thank you for your exceptional and detailed response to my question. I am just getting my feet wet with the trailer life. Thank you, Anthony

Kate F.

2/23/2026

@AnthonyM That sounds like a fun build. A 5x10 toy hauler for an adventure bike is a great lightweight setup for boondocking. You would not need a separate deep cycle battery or inverter if you go with the Goal Zero 1500. It already has a lithium battery, built-in inverter for 120-volt power, and 12-volt outputs. It is basically an all-in-one power unit. Yes, you can use it to power things outside the trailer directly. You can also plug your trailer’s 15-amp or 20-amp exterior inlet into the Goal Zero’s 120-volt outlet with a standard cord. That will power your interior outlets like you are plugged into shore power. If you add a 30-amp inlet, you can still use it with a 30A to 15A adapter. Just remember you are still limited to about 1500 watts, so you will need to manage what is running at the same time. If you are mainly running lights, charging devices, maybe a fan or small appliance, the Goal Zero is a simple and clean option. If you plan to run bigger items like a microwave or air conditioner, a traditional RV lithium setup would give you more flexibility long term.

Anthony

2/24/2026

@KateF If I wanted to have some 120v outlets close by could I just connect 3 outlets in parallel and plug the origin into the 120 ac plug of the Goal Zero? Would I need a breaker box and circuit breakers? I am so appreciative of your advice.

Kate F.

2/26/2026

@Anthony I would not recommend wiring three outlets together in parallel and plugging that into the Goal Zero. While outlets in a home are wired in parallel, they are protected by a breaker panel upstream. Simply tying outlets together without proper circuit protection is not the safest way to build out your trailer. If you want multiple 120-volt outlets installed inside the trailer and done correctly, the right way to do it is with a small breaker panel and distribution system. That’s where something like the Progressive Dynamics 4000 Series Mini RV Converter w/ Charge Wizard and AC/DC Distribution Panel # PD4045KA comes in. It gives you a proper 120-volt breaker panel to protect your outlets, and it also includes a converter to charge a dedicated 12-volt battery bank for your lights and other DC accessories. In that setup, your exterior 15-amp or 30-amp inlet would feed the # PD4045KA. From there, your outlets would be wired to individual breakers, and your 12-volt circuits would run off a real battery bank. That is the safe, RV-correct way to build a permanent system. If you plan to stick with the Goal Zero as your main power source, the simplest and safest route is honestly just using a heavy-duty power strip or extension cord rather than hard-wiring outlets. Once you move into permanent wiring, a proper panel like the PD4045KA and a dedicated battery bank is the better long-term solution.

Helpful Links

tv-demo-progressive-dynamics-rv-converters-power-converter-w-charge-system-pd4045ka.aspx

See All (5) Replies to Anthony M. ∨

Answer 1

Hey Ronald, Besides replacing the batteries themselves, we have a converter that is a good replacement for yours to tackle those lithium batteries. The Progressive Dynamics 9300 Series #PD79RR is what I would recommend. It is similar in terms of…

view full answer...

Answer 2

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 3

You can use the RV Propane Gas Detector #RS64FR (white) or #RS44FR (black) to replace your current Atwood 31013 propane gas detector. This will also use a 12v, 2-wire installation like your current detector.

view full answer...

Answer 4

The closest replacement an Atwood PPOO224730 33535E propane detector is the RV Propane Gas Detector - 12 Volt - 2 Wire - Black item #RS44FR. It only uses one power wire instead of two so it is slightly different. It measures 4-1/4" long x…

view full answer...

Answer 5

The closest option we'll have to your Atwood 33535E LP/CO2 Detector is going to be the RV Propane Gas and Carbon Monoxide Detector #RS54FR that you were already looking at. It comes with two mounting plates to try and eat up some of your old…

view full answer...

Answer 6

Hello David. I see that you are looking at getting two of the Go Power Sun Cycle Advanced Lithium RV Battery #GP99QR. For a cable you can use the Go Power Inter-Battery Communication Cable #GP56QR. For resistor caps you can use part #GP36QR.

view full answer...

Answer 7

I spoke with Furrion and was informed that back in November the company that they paired with for service dropped the accounts so the Furrion Access RV 4G LTE Router w/ WiFi Extender #FAN17B8B will currently only function as a wifi extender. They did…

view full answer...

Answer 8

The Replacement Glass Top for Furrion 2-in-1 Range Oven part #C-FSRE21SA-SS-003 is what you need to replace the glass top on a Furrion 2-in-1 Range Oven (FS17WB4A-BL) which is the same as our Furrion 2-in-1 Range Oven part #FSRE17SABL that is now…

view full answer...

Answer 9

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 12

Hey Andrew! Yes, Furrion does have a Chill Cube model with a heat pump. This was actually just released for aftermarket sale. You will need a complete system to make the switch, new R32 units aren't backwards compatible with old R410A systems.…

view full answer...