Is The TRU59FR Spindle An EZ-Lube Spindle?
Published 12/26/2025
Question:
Hello, Is this spindle actually EZ-L ube. It shows that it is in the picture.
asked by: Cassandra
0
Expert Reply:
Hey Cassandra,
The TRU59FR spindle is not an EZ-Lube spindle. It is a weld on spindle that does not have a built in grease fitting in order to grease the hubs, you would have to do that the standard way by removing the hub. I do not see a spindle that we carry that is a EZ-Lube spindle.
What kind of trailer are you looking to replace this on?
expert reply by:
Nick S
0
Product Page this Question was Asked From
BT8 Spindle for 2,000-lb Trailer Axles - 1-3/8" Diameter
- Trailer Spindles
- Standard Spindle
- Without Flange
- L44643
- 1-3/8 Inch Diameter
- Round
- For 2000 lb Axle
- TruRyde
more information >
Continue Researching
- Q&A: What Inner and Outer Bearings Does 3,500 lb Axle Disc Brake Kit Use
- Q&A: Replacement Brake Setup for Trailer with DB-42 Disc Brakes
- Q&A: What is Diameter of Trailer Axle w/ Electric Brakes # LC82FC
- Q&A: How to Pick Out Replacement Hubs for a Boat Trailer
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Can I Replace Bolt-On Spindle With Weld-On Spindle
- Q&A: Replacement 3,500 lb Disc Brake Kit for a 2004 Ranger Boat Trailer
- Q&A: How to Tell if Trailer has a BT8 or BTR Spindle Installed
- Article: Trailer Wiring Diagrams
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Trailer Lighting Requirements
- Article: Most Popular Wheel Bearings