Where Does Kat's Heaters Custom Engine Block Heater Install on 2013 Ford Escape 2.0 EcoBoost
Updated 12/29/2025 | Published 12/14/2025 >
Question:
Where does the block heater install on a 2013 ford escape 2.o ecoboost
asked by: Bruce S
0
Expert Reply:
Hi Bruce; the Kat's Heaters Custom Engine Block Heater # KH11409 installs on the rear/passenger side of the block. It will be low on the engine block, just above the oil pan rail. You will find it roughly midway between cylinders 2 and 3, very close to the transmission bellhousing flange. I don't have a diagram I can give you since Kat's Heaters stopped responding to questions about installation locations a long time ago.
expert reply by:
Robin H
0
Product Page this Question was Asked From
Kat's Heaters Custom Engine Block Heater - Frost Plug Style - 120V - 400 Watts - 3/4" NPT
- Vehicle Heaters
- Engine Block Heater
- Frost Plug Style
- 400 Watts
- CSA Approved
- Kats Heaters
more information >
Continue Researching
- Shop: Kat's Heaters Custom Engine Block Heater - Frost Plug Style - 120V - 400 Watts - 3/4" NPT
- Shop: Vehicle Engine Heaters
- Q&A: How To Install Kats Engine Block Heater KH97VR On 2024 Ford F-150
- Q&A: Where to Install Engine Block Heater On a 2011 Ford Flex With 3.5L Non-Ecoboost Engine
- Q&A: Recommended Engine Warmer for a 2016 Ford Focus with 2.0 Engine
- Q&A: Where is the Port for the Block Heater # KH11815 on a 2018 Ford F-150 with a 3.5L V6 EcoBoost Engine
- Q&A: What Video Interface does the USB Camera Adapter for Edge CTS3 Monitors Use?
- Q&A: Installation of Kat's Engine Heater in a 2013 Mazda CX-p
- Q&A: Recommended Block Heater Recommendation for 2015 Ford Focus
- Article: Performance Chips and Modules
- Article: Rooftop Cargo Carriers
- Article: How to Correct Noise from Exhaust Rattling Against a Trailer Hitch
- Article: Which Hitches are Made in the USA
- Article: The 5 Best Trailer Drop Hitches You Can Buy
- Article: Trailer Wiring Diagrams
- Article: Snow Tire Chain Overview: How to Buy the Right Tire Chains



Robin H.
12/29/2025
Hey Bruce, did you end up finding the spot for the block heater on your Escape’s engine? Knowing how it lined up near the oil pan could help others trying the same install. Your update could make it easier for the next person with this setup.