How To Wire Up Furrion Vision S+ Wireless RV Backup Camera FR24AD

Updated 12/08/2025 | Published 11/12/2025

Question:

How does the camera wire up? The directions werent very specific.

asked by: Duke

Expert Reply:

Hello Duke, thanks for reaching out. I think Furrion makes the instruction intentionally vague because they want you to take it to a shop and have the camera system professionally installed. I can definitely provide some further instruction for wiring it yourself.

To wire a Furrion Vision S+ Wireless RV Backup Camera, mount the camera on the rear of your RV, usually at the top center. Connect the red wire to a 12-volt power source, either the reverse-light circuit so it only comes on when backing up, or the running-light circuit so it stays on with the lights. Connect the black wire to a solid chassis ground. If your system includes side cameras, you can attach the yellow trigger wires to the turn-signal circuits for automatic switching.

After wiring, pair the camera to the monitor through the on-screen pairing menu, then mount the monitor on your dash or windshield and power it with the included 12-volt plug. Turn on the vehicle or lights to check the image, adjust the camera angle, and seal all screw holes and wire entries to keep out moisture.

I hope this helps. Let me know if you have any other questions.

expert reply by: Jesse M

Jesse M.

12/8/2025

Hey Duke, how did things go getting your Furrion Vision S+ camera wired up and paired with the monitor? It’d be great to hear if the power and trigger connections worked as expected. Your update could make it easier for others wiring the same system.