Does Spindle Nut Have to Use Washer
Updated 10/22/2025 | Published 09/24/2025
Question:
For a bearing number 44643 do I need a washer between the bearing and nut. I was told no. Then 50/50 when I looked it up online. Can’t get the nut threaded on enough to clean the pin hole. Without the washer I have enough clearance.
asked by: Andrew
0
Expert Reply:
Hey Andrew, you can leave the washer off and you'll be just fine. If you can fit the washer on then that's great but if it prevents getting to the cotter pin it's not worth it.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Hub Bearing Kit for Lippert, Dexter, and AL-KO Axles - 3,500 lb with #84 Spindle
- Trailer Bearings Races Seals Caps
- Bearings
- Standard Bearings
- Bearing Kits
- Bearing L44649 and L68149
- Race L68111 and L44610
- 3500 lbs Axle
- etrailer
more information >
Continue Researching
- Article: Most Popular Wheel Bearings
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: Bearing Kit for Lippert 4,400 lb Trailer Axle
- Q&A: Bearing and Seal Kit for Lippert 4.4k Trailer Axle
- Article: Trailer Wiring Diagrams
- Q&A: What is a #84 Spindle and How Do I Know I Have One On My Trailer?
- Q&A: Availability of USA Made Bearing Kit for 3,500 lb Trailer Axle
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Q&A: Replacement Bearing Kit for a 2022 Grand Design Transcend Xplor 265BH
- Q&A: Replacement Bearings, Races, Grease Seals & Brakes For Lippert 4,400LB Axle On Jayco Travel Trailer
- Q&A: How to Determine Replacement Trailer Wheel Bearing Sizes
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision
- Article: How to Bleed Your Trailer Surge Brakes
Jameson C.
10/22/2025
Hey Andrew, how did things turn out with the bearing setup on your hub kit? Were you able to get the nut aligned with the cotter pin hole after leaving the washer off? Your results could help others sorting out the same fit issue.