How Does Orbital 10" Buffer Keep Bonnet Cloth From Flying Off?
Published 09/24/2025
Question:
I’m new to detailing. How do you keep the bonnet from flying off while polishing?
asked by: Steve
0
Expert Reply:
That’s a common concern, Steve. With the # PT37VR, the bonnets stretch over the 10inch pad and have an elastic edge to keep them snug. The trick is to make sure the bonnet is seated evenly all the way around before you start. If you load too much compound or polish in one spot, it can cause slipping, so apply in small amounts and work it in gradually.
Have you picked out a compound or polish yet? We can match one to your application if you don't have it yet.
expert reply by:
Andrew N
0
Product Page this Question was Asked From
Orbital Buffer - Random Action -10" Diameter - 3,000 rpm
- Car Polisher
- Polisher
- 3000 Orbits Per Minute
- 10 Inch Diameter
- Performance Tool
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: Recommended Replacement Jack for AL-Ko MD285 Trailer Jack
- Q&A: Rear Anti-Sway Bar For A 2020 F-350 Super Duty Dually
- Q&A: What Hellwig Rear Sway Bar Fits a Lifted 2021 Ford F-250?
- Q&A: Recommended Anti-Sway Bars For A 2023 Ford F350 4WD
- Q&A: Does The Orbital Buffer For Detailing Cars Have Single Speed Or Variable Speed Settings?
- Q&A: Is Performance Tool Orbital Buffer The Same As Rotary Buffer?