How/Where To Mount Quick Connect For Rear View Safety Backup Camera System RVS-770613-213
Updated 08/21/2025 | Published 08/17/2025
Question:
How do I mount the quick connect connector to my tow vehicles bumper?
asked by: Doug J
0
Expert Reply:
Hello Doug, thanks for reaching out. You will need to drill a hole in the vehicle body to mount the quick connect. The exact location depends what vehicle you are putting it on, but you will want to put it in a location near the rear where it can be mounted flush with the body of the vehicle. Like for example if you are pulling a 5th wheel you could put the quick connect in the bed of the truck.
expert reply by:
Jesse M
0
Product Page this Question was Asked From
Rear View Safety Backup Camera System with Trailer Tow Quick Connect Kit
- Backup Camera
- Camera Systems
- Rear Mount
- Hardwired
- Wide View
- Video Monitor
- Medium
- Backing Up
- Towing Visibility
- Rear View Safety
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Back Up Camera For an In Bed Camper
- Q&A: Adapter to Fit Pullrite Superglide ISR Hitch to OEM Pucks of 2026 Ram 3500
- Q&A: What is Outer Tube Diameter of Trailer Valet Jack # TV57ZR
- Q&A: Will The B&W Anti-Rattle Clamp BW45FR Work With The Tow & Stow Ball Mounts?
- Q&A: Looking For Hitch Extender Rated For Over 5,500 lbs And Can Be Used With Weight Distribution System
- Q&A: Will a PullRite 2900 SuperGlide from a 2022 GMC Sierra Fit a 2025 RAM 2500 w/ the Puck System?
- Q&A: Frame Mounted Camper Tie Downs For 2024 Ram 3500 With 6.4' Bed And Cab Length Steps
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Ram Trailer Tow Prep Package
- Article: Which RV Propane Tank Size Do I Need?
- Article: Flat Towing Package for 2025 Ford Escape
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Big Truck Big RV
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
Doug
8/21/2025
Can you provide more detail or you-tube video link(s) for a 2024 jeep grand Cherokee installation? Should connector flush mount in the hole or use the half moon bracket supplied in the kit....