Slider B and W Companion Hitch to Fit 2023 Ford F-350 without OEM Pucks
Updated 09/02/2025 | Published 08/02/2025
Products Featured in This Question
Question:
I have a 2023 F-350 with out the factory 5th wheel prep kit. I want a BandW slider hitch. What are my options for DIY install ? Thanks.
asked by: Jim
Expert Reply:
Hey Jim, we have just what you need to install a B and W Slider Companion hitch in the bed of your 2023 Ford F-350 short bed with the rail kit/gooseneck hitch part # BW73FR and then for the slider hitch to fit that you'd need the # BWRVK3400 and you'd be set.
This hitch installs by attaching to the gooseneck attachment of the Turnoverball and gives you the slider hitch you are looking for.
Product Page this Question was Asked From
B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit - 30,000 lbs
- Gooseneck Hitch
- Below the Bed
- Flip-Over Ball
- 7500 lbs TW
- 30000 lbs GTW
- Wheel Well Release
- Spring-Loaded Loop
- B and W
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: What Is An OEM Prep Package And How Do I Know If I Have It
- Q&A: Will Curt T-Connector Vehicle Wiring Harness Fit 2025 Ford F-350
- Q&A: Correct Gen-Y Hitch Gooseneck Pin Box for 2025 Jayco Eagle 317ROLK
- Article: Gooseneck to 5th Wheel Adapters
- Q&A: Where Does The Red Wire Install to On the Roadmaster Brake-Lite Relay Kit 2007 Hummer H3
- Q&A: Are Inner Brackets of B and W Gooseneck Hitch Needed When Installing In 2026 Ford Truck
- Q&A: B&W Turnoverball and Gooseneck Wiring for 2025 Ford F-250
- Q&A: Can Door Be Replaced On Mighty Cord Replacement RV Power Inlet
- Article: Ram Trailer Tow Prep Package
- Article: Converting Your RV Water Heater to Tankless
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 5th Wheel to Gooseneck Adapters
Jameson C.
9/2/2025
Hey Jim, did the B and W Slider Companion hitch and rail kit work out for your DIY install on the F-350? I'm asking because your experience could help others looking to do the same.