Could Machine Shop Remove Pin of Andersen Rapid Hitch Ball Mount
Updated 07/23/2025 | Published 07/16/2025
Question:
I’ve tried everything even a slide hammer to remove internal pin on my Andersen adjustable hitch, but nothing works. Is it possible to have a machine shop drill the pin out and replace with a new one?
asked by: Michael W
0
Expert Reply:
I am pretty confident if you took it to a machine shop they would have a way to either extract the pin or drill out the old one. None of us here have worked at a machine shop though so we aren't super familiar with exactly what tools they might use.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Ball Housing for Rapid Hitch AM3400 Series
- Accessories and Parts
- Trailer Hitch Ball
- Ball Housing
- Andersen
more information >
Continue Researching
- Q&A: If Wesbar Lens 003372 for Left or Right Side of Trailer
- Q&A: Do Powered Jacks Only Need One Wire Ran to Them
- Q&A: Replacement Orifice Fitting For A Titan Disc Brake Actuators
- Q&A: Front Hitch for 2004 Jeep Wrangler that Installs Under Front Bumper
- Q&A: Does the Front Mount Trailer Hitch Install Above or Below the Front Bumper on a 2004 Jeep Wrangler
- Q&A: How to Remove Hitch Ball Component of Rapid Hitch Adjustable Aluminum Ball Mount AM3411
- Q&A: Replacement Trailer Taillight Lens for Part Number AS2T216
- Article: Trailer Hitch Installation Tips
Michael W.
7/23/2025
I didn’t take it to machine shop. Decided to buy new part with pin. Figured time and cost would be almost the same. I am unhappy about Anderson though. They need to address this issue. Maybe advise when you purchase to lube internal pin at first and yearly after.