Can The LC182495 Lift Extenders Bolt Work With Atwood Jacks?
Updated 08/15/2025 | Published 07/16/2025
Question:
can these work with atwood jacks?
asked by: Kenny
0
Expert Reply:
Hello Kenny, thanks for reaching out. The # LC182495 Lift Extenders are designed to be used with HappiJac Truck Camper Jack Systems. They may work with Atwood jacks, but this is not something we have tested. Basically, as long as the Atwood jack has the same bolt hole spacing (3-1/8" on center) the extenders would bolt up and work fine.
expert reply by:
Jesse M
0
LC182495 Lift Extenders Bolt Hole Spacing
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Lift Extenders for HappiJac Truck Camper Jack Systems - 6" Lift - Qty 4
- Accessories and Parts
- Camper Jacks
- Trailer Jack
- Lift Extenders
- HappiJac
more information >
Continue Researching
- Shop: Suspension Enhancement
- Shop: TorkLift StableLoad Suspension Upgrade w Quick-Disconnect - Lower Overload Springs - Stainless Steel
- Q&A: Recommended HappiJac Extender Bracket for Dually Trucks
- Q&A: Recommended Swing Out and Extension Brackets for a Happijac Truck Camper Jack System
- Q&A: Is Wiring Extension Needed with Happijac Bracket Extensions
- Q&A: Best Wheel Chock and Leveler for a Class C Motorhome
- Q&A: Can I Use The Pacbrake Air Bag and Compressor Kit on my 2026 450 SuperDuty With on Board Scales
- Q&A: Edge to Edge Measurement of MORryde Sliding Tray for RV Cargo Compartment
- Article: How to Mount a Truck Bed Camper
- Q&A: How to Turn Off 12-V Power Feed to 7-Way Trailer Connector on Vehicle When Ignition is Shut Off
- Article: Stability Control for Heavy Duty Vehicles
- Article: Wiring Trailer Lights with a 6-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Our Team Picked The Best Camping Gear of the Year - Here Are Their Top Choices
- Article: Trailer Wiring Diagrams
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
Jesse M.
8/15/2025
Hey Kenny, did you get a chance to check if the bolt hole spacing on your Atwood jacks matches the 3-1/8 inches needed for the lift extenders? I'm curious to know if it worked out for you, as it could help others with the same setup.