How Many Bolts Hold Demco Replacement Master Cylinder to Actuator
Updated 06/25/2025 | Published 06/24/2025
Question:
Hi, to install the 5672 do you just remove the 4 bolts that hold it in place and pull the cylinder out ? Or do you have to remove the whole assembly to get it out? Thanks Joey
asked by: Joey S
0
Demco Surge Actuator
(click to enlarge)
(click to enlarge)
Expert Reply:
Hey Joey, yes to remove and install the Replacement Master Cylinder part # 5672 it is just a matter of removing the four bolts as that is all that holds it in place.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Replacement Master Cylinder for Demco Actuators - Disc Brakes
- Accessories and Parts
- Brake Actuator
- Disc Brakes
- Master Cylinder
- Demco
more information >
Continue Researching
- Q&A: Replacement Brakes For Demco Kar Kaddy SS Tow Dolly
- Q&A: Replacement Hub Assembly for Demco Kar Kaddy
- Q&A: What is the Difference Between Demco Kar Kaddy X and SS Tow Dollies?
- Q&A: Replacement Caliper Solution for Tie Down Engineering 46304
- Q&A: Recommended Replacement Master Cylinder for a Demco Hydrualic Brake Actuator
- Q&A: Comparing EZ Haul and Demco Kar Kaddy SS Tow Dollies for Storage
- Q&A: Replacement Cable for Dexter Parking Brakes
- Article: Parts Needed to Add Hydraulic Disc Brakes to a Trailer
- Article: How to Bleed Your Trailer Surge Brakes
- Article: The Ultimate RV Camping Checklist for Your First Year RVing
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
Joey
6/25/2025
Great , thank you!