Is Pivot Hole for etrailer SD Tow Bar # e37ZR Slotted and Allow Movement
Updated 09/12/2025 | Published 05/20/2025
Question:
I have an etrailer SD tow bar and I have noticed that the bar is shifting up and down at the bolt closest to the motorhome. I have checked the torque and it good. The hole is oblong so I’m guessing the movement is normal but I wanted to check. Thank you
asked by: Shawn
0
Expert Reply:
Hey Shawn, yes the hole that attaches the pivot assembly to the shank of the etrailer tow bar part # e37ZR is slotted to allow some movement so what you are experiencing is normal.
expert reply by:
Jameson C
0
Shank Assembly
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
etrailer SD Non-Binding Tow Bar for Reese or Valley Base Plates - RV Mount - 2" Hitch - 6K
- Tow Bar
- Hitch Mount
- Telescoping - Non-Binding
- Steel
- 6000 lbs
- Fits Reese Base Plates
- Fits Valley Base Plates
- Stores on RV
- Cables Included
- etrailer
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Recommended 7-Way to 6-Pole Flat Tow Trailer Connector That Works w/a Charge Line
- Q&A: Is Vevor RN-QVR 7500 Tow Bar Compatible With Blue Ox Base Plates
- Article: Trailer Wiring Diagrams
- Article: Flat Towing Package for 2007-2018 JK Jeep Wrangler and Wrangler Unlimited
- Q&A: Best Blue Ox Flat Tow Setup for 2026 Jeep Wrangler
- Q&A: Parts Needed to Flat Tow a 2005 Saturn Vue Behind an RV
- Article: Best Bike Racks for Electric Bikes
- Q&A: 7-Way to 6-Way Recommendation for Flat Towing a Jeep Wrangler
- Q&A: 6-Pin Connector For Front Of Jeep Wrangler When Preparing For Flat Towing
- Q&A: Parts Needed to Flat Tow 2007 Chevy HHR
- Article: Roadmaster Vehicle Specific Base Plates
- Article: Flat Towing Package for 2006-2007 Chevrolet HHR
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: How to Choose a High-Low Adapter
Jameson C.
9/12/2025
Hey Shawn, I'm glad I could confirm that the movement you're seeing with your tow bar is normal. How has it been working for you since you checked the torque? I'm asking because your experience could help others who have similar concerns.