BulletProof Hitches 2-Ball Mount Measurements
Updated 10/22/2025 | Published 04/10/2025 >
Question:
What is the distance from the center of the rear 5/8inch pin hole to the nearest edge of the top of the ball mount platform?
asked by: Ryan
Expert Reply:
Hey Ryan! Are you referring to the vertical part where the adjustment holes are? The distance from the center of the hitch pin hole to that edge is 9-3/8". I went ahead and added this to the diagram below which has some other measurements from the # HD206 that might be helpful.
If you're actually looking for a measurement to the top of the ball mount platform I suppose it depends on what position it is installed in and where you consider the closest part of the top edge to start. If you can mark on the picture what you're looking for and respond in an email I would be happy to find it if none of the measurements below are helpful.
Product Page this Question was Asked From
BulletProof Hitches 2-Ball Mount for 2" Hitch - 7-1/4" Drop, 7-1/2" Rise - 22,000 lbs
- Trailer Hitch Ball Mount
- Adjustable Ball Mount
- Two Balls
- 2 Inch Ball
- 2-5/16 Inch Ball
- Steel Shank
- Drop - 7 Inch
- Rise - 7 Inch
- Fits 2 Inch Hitch
- 12000 lbs GTW
- 22000 lbs GTW
- BulletProof Hitches
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Does BulletProof Hitch Offer A Ball Platform With A Single 2-5/16" Ball?
- Q&A: Do You Have a 2-inch Square Axle Rated for At Least 3,000lbs and Has Idler Hubs?
- Q&A: Is there a Replacement for Dexter Nev-R-Lube Hub 008-386-80
- Q&A: Recommended Lock For A Demco 2-5/16" EZ Latch Coupler
- Q&A: Are BulletProof Aluminum Ball Mounts Raw Aluminum Or Are They Coated?
- Q&A: What Replacement Rotors and Brake Pads do I Need for My Kodiak Disc Brakes K2HR12A11-120DW?
- Q&A: Will EcoHitch Front Hitch Fit with Aux Cooler on a 2024 Ford F-450 Platinum
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Trailer Hitch Drop
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Testing Breakaway Systems
- Article: Trailer Lighting Requirements
- Article: 7 Common Questions Everyone Has About Trailer Tires




Robin H.
10/22/2025
Hey Ryan, did the measurements on the BulletProof ball mount diagram give you the info you needed? Once you confirmed the exact spot you meant, it’d be great to hear if the numbers lined up for your setup. Your feedback could help others trying to gauge the same distance.