Finish Of # AM90077 Stainless Steel Trailer Wheel Center Cap

Question

Question:

Got a question regarding your AM 90077 stainless steel 4.5 center it says its stainless steel. is it black or polished s.s. thx

asked by: G.ayala

0

Expert Reply:

The Americana Trailer Wheel Center Cap, part # AM90077 is made of polished stainless steel and fits pilot holes that measure 4.25 to 4.27 inches. This cap also comes with a black plastic plug that is removed easily for maintenance. This will fit 15 and 16 inch wheels with a 6-hole bolt pattern.

expert reply by: Jeffrey L

0

Answer 1

I went and measured the depth of the Americana Trailer Wheel Center Cap #AM90077 and found that from the top of the cap to the bottom when measured from the inside it is 4.34 inches deep.

view full answer...

Answer 2

Hey Mike, We sell replacement studs in single or multiple quantities depending on the specific sizing. For a 3,500lb trailer hub you most likely need the #DE52GR but I recommend punching one of your current ones out and comparing. The #DE52GR is…

view full answer...

Answer 3

I do have an option for you though we don't carry the exact same style of wheel the trailer came with from the factory. That said, it's just a spare wheel after-all so you don't really need an exact style match since it won't even be…

view full answer...

Answer 4

Hello Kevin. The wheel you are referring to is called the Sendel Series T09 5-Spoke Machined Silver Aluminum Rim. I am sorry to say that we do not offer this exact wheel is a 16" 8 lug. We do have some pretty similar 16" 8 lug aluminum…

view full answer...

Answer 5

If the outer diameter of your spindle where the seal rides is 1.719 inches and the diameter on your hub is 2.565 the #RG06-050 would be the closest matching grease seal we offer. You will need a digital or dial caliper for this measurement like…

view full answer...

Answer 6

Hi Lane, The closest option we have to the measurements you provided would be the DeeMaxx Drive-In Wheel Stud - 1/2" Diameter x 2" Long #DE52GR.

view full answer...

Answer 7

Hello Lawrence, thanks for reaching out. Sadly, the only Aluminum Jaguar wheel we offer is the 16" #274-000011. I wish we did have these available in other sizes because we get asked about this a lot. To my knowledge the 15" jaguar wheels…

view full answer...

Answer 8

Hey Joe, for your Axle Tek hub BD2-545-17 our part number #AKHD-545-35-K the correct replacement wheel stud would be the part #DE52GR.

view full answer...

Answer 9

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 10

The three most common lug stud sizes for a trailer are 1/2"-20, 9/16"-18, and 5/8"-18. In order to make sure you get the correct lug nuts you need to measure the lug studs on the trailer now as we have no way to look this up for…

view full answer...

Finish Of # AM90077 Stainless Steel Trailer Wheel Center Cap

Product Page this Question was Asked From

Continue Researching