What are the Pipe Mount Dimensions for etrailer Square Pipe Mount Swivel Jack?
Updated 10/27/2025 | Published 03/23/2025
Products Featured in This Question
Question:
Would you have the dimensions of the male weld on pipe on parts TJDP-7000-B and TJDP-5000-FLB as well as the pin hole diameter? Thank you
asked by: Will
0
Expert Reply:
Hey Will! The weld on pipe mount diameter on both the item # TJDP-7000-B and item # TJDP-5000-FLB jacks is 2" on the inner and 2-1/2" on the outer. The mounting point on the jacks has diameters of 2-1/2" on the outer tube width and 2-1/4" on the inner tube width. The pin hole is slightly larger than 5/8" and takes a standard 5/8" pin like the item # TJD-7000-PN.
expert reply by:
Jerred H
0
Pipe Mount
(click to enlarge)
(click to enlarge)
Product Page this Question was Asked From
Square Pipe Mount Swivel Trailer Jack w/ Foot - Drop Leg - Topwind - 15-3/8" Lift - 7,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Topwind Jack
- 6001 - 7000 lbs
- Manual Jack
- 29 Inch Lift
- Weld-On
- With Rectangle Foot
- etrailer
more information >
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Will B and W Fifth Wheel to Gooseneck Adapter Void Lippert Warranty
- Q&A: Replacement Light for a Bargman 48-84-527 Light Assembly
- Q&A: Material of D Washer for EZ Lube Spindle
- Q&A: Recommended Bolt On 7,000 lbs Capacity Square Jack
- Article: What RV AC Will Work With Your Setup? Avoid Costly Mistakes Before You Order
- Q&A: Does etrailer Carry 3,500 lb Torsion Axles
- Q&A: Is There A 1.5" Hitch To 2" Hitch Adapter?
- Q&A: Parts Needed To Install Curt Echo In-Line On 2025 Kia Telluride Without Trailer Wiring
- Article: How to Mount a Truck Bed Camper
- Article: How to Measure a Trailer Axle
- Article: How to Raise Your Travel Trailer Height
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
Jerred H.
10/27/2025
Hey Will, did those dimensions for the weld-on pipe mounts on the jacks give you what you needed? Knowing how they matched up could help others checking fit for similar setups.