Can A 12v Redarc Brake Controller Be Installed On A 24v Vehicle?
Updated 03/16/2025 | Published 03/09/2025 >
Products Featured in This Question
Question:
Hello, Looking for a 24 volt compatible brake controller to use on Japanese domestic commercial vehicles to tow U.S. model trailers equipped with 12 volt electric brakes. Will this Redarc controller output the required 12 volts although the tow vehicle is 24 volt? Thanks
asked by: Patrick
Expert Reply:
Hello Patrick, thanks for reaching out. It is possible to install a brake controller on a vehicle with a 24 volt system. You will need to install a 24v relay to do so. I have included a diagram for you below that shows how the relay would wire to the vehicle and to the brake controller.
As long as you follow the diagram, you could install any 12v brake controller, such as the Redarc # RED52VR, which comes with a universal harness.
Product Page this Question was Asked From
Redarc Tow-Pro Trail Brake Controller w/ Custom Harness - Dash Knob - Off-Road Mode - Up to 3 Axles
- Trailer Brake Controller
- Proportional Controller
- Electric
- Electric over Hydraulic
- Plug-In
- Dash-Mounted Knob
- Behind-Dash
- Up to 3 Axles
- Indicator Lights
- Single Trailer Only
- Redarc
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Differences Between the Redarc Tow Pro Trail and Elite
- Q&A: Recommended Solar Fans for Built Up Heat in a Cargo Trailer
- Q&A: Difference Between Redarc Tow-Pro Elite and Tow-Pro Trail Brake Controllers
- Q&A: T- Slot Rack Options For a RetraxONE XR Tonneau Cover on a 2023 Nissan Frontier With 5' Bed
- Q&A: Parts Needed to Install Redarc Tow-Pro Trail on 2025 Nissan Frontier
- Q&A: What Mounting Panel Do I Need to Install a Redarc Brake Controller in a 2026 Frontier?
- Q&A: Recommended Brake Controller for 2025 Nissan Frontier
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: How to Install a Weight Distribution Hitch (With Pictures & Video)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)



Patrick
3/16/2025
Thank you for the explanation. Although this is the way we are currently wiring up our fleet vehicles, I should have been more specific. The Redarc RED63RR is actually 24v compatible without the relay and based on the literature for this model, it does not specify the output voltage to the 12v electric brakes. There is an illustration showing a 24v in from stop lights with a 12v output wire to the electric brakes therefore one would assume the controller has the ability to reduce 24v power input, down to the required 12v output. Just wanted to verify this before pulling the trigger. Thanks